4-6 This Button will only appear if the machine type is 0 or 4. It should be set from the factory to
the width of your machine. It will toggle between 20”, 26” and 30” each time it is touched.
Once the number of plates in the Parallel are set this button will disappear. Verify the settings
are correct before setting the number of plates in the parallel.
4-7 Press this button to tell Autoset if you want to display the optional exit sensor count in place
of the standard infeed count. It will toggle between yes and no each time it is touched.
4-8 Press this box to tell Autoset if you have the optional Gatefold plate. It will toggle between
yes and no each time it is touched.
4-9 Press this button to tell Autoset how many plates you have in the 16page unit. It will
increment thru 0 2 3 4 6 each time you touch this box. If you do not have a 16page unit leave
it set to 0
4-10 Press this button to tell Autoset how many plates you have in the 8page unit. It will increment
thru 0 2 3 4 6 each time you touch this box. If you do not have an 8page unit leave it set to 0
4-11 Press this box to tell Autoset how many plates you have in the parallel unit. It will increment
thru 0 2 3 4 6 each time you touch this box.
4-12 Machine Type, this button should be set from the factory. 0 = Autoset (DO NOT CHANGE).
Once the numbers of plates in the Parallel are set, this button will disappear. Verify the
settings are correct before setting the number of plates in the parallel.
III. AUTOSET STARTUP PROCEDURE
The Autoset software should start-up automatically when the machine is turned on. The Autoset
power switch on the side of the main control box needs to be switched on; the switch is lighted and will show
green when the switch is in the on position. This power switch controls the power to the Autoset motor
controllers. If for any reason it does not start up properly cycle power to the machine. If the Autoset software
still will not start up contact your local dealer for support.
IV. AUTOSET SHUT DOWN PROCEDURE
It is very important to shut down the Autoset properly before turning off the machine. Before
powering down the machine press the
button to start the power down procedure. A pop up box will appear asking if you are sure you want
to power down. Press OK. From this point the power down is automatic. Once the screen reads it is OK to
turn off your computer you can shut down the machine with the main disconnect on the side of the main
control box. The Autoset power switch doesn’t need to be switched off. The purpose of the Autoset power
switch is to turn off power to the Autoset drive controllers during reconfiguring the machine so that the
network connections can be broken and reattached with out turning off the Autoset computer.
