4-in-1 Multifunction Baby Bottle Warmer
EN
10
Operation
!
Attention:
Never use the bottle warmer without water in the heating tank!
Stand the bottle warmer on ahorizontal and stable surface.
The steam that is released during the warming process is hot. Always keep your
hands away from the bottle warmer during the warming process.
Warming up baby bottles
■Put the baby bottle attachment A3into the body of the appliance A2and then put
the baby bottle bottle into it (figure D1).
■Pour the corresponding amount of water into the body of the appliance A2using the
measuring cup A1(figure D2). The amount of water should be equal to the
amount of milk in the baby bottle.
Always place afully assembled baby bottle into the bottle warmer including its screw
top and nipple (without the dust cap). Make certain that you pour water into the
bottle warmer before turning it on. Never allow water to rise above the neck of the
bottle or to spill over the edge of the bottle warmer. The water must not exceed the
"MAX" level marked inside the body of the appliance.
■Cover the bottle warmer with the lid A1, (figure D3). Check that the lid A1has
properly adhered to the body of the appliance A2.
■Start the bottle warming function by pressing the On/Off button of the appliance B1
and subsequently selecting the baby bottle warming function B2andC6. The LCD
display shows the preset time of 3 minutes.
The warming time can be decreased or increased using buttons B3, B4. After three
seconds, if no other functions are set, the bottle warmer will start the warming function
and acountdown will be shown on the LCD display.
■When the bottle warming process is complete, the bottle warmer will make asound
and the LCD display will show the temperature of the warmed milk C4.
■Turn off the appliance and disconnect it from the power socket.
■To remove items from the bottle warmer, use the tongs A6, which are apart of the
product.
■Always test the food once it reaches the desired temperature, immediately remove it
from the bottle warmer.
Shake the baby food or milk after taking it out of the bottle warmer. Check the
temperature of the food or milk by dripping alittle on your wrist.
■Allow the bottle warmer to cool down before using it again. The bottle warming
function can be repeated after 30 minutes.
