UPDATED LAST: June 2018
WWW.BBKPERFORMANCE.COM
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
tech@bbkperformance.com
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
STEP 1
This picture (Note) As the arrow shows this is the draw side of the oil separator.
The hose that goes to the intake manifold will attach to this end.
STEP 2
Remove factory PCV hose then install Oil Separator Kit as shown in picture.
Making sure the shorter hose goes to intake manifold/draw side.
STEP 3
sdfsdafasdf
dsafdsaf
sadfasdfa
STEP 4
Make sure to use supplied clamps at engine connections.
