BCP SKY1760 User manual

SKY1760Ver. 3
INSTRUCTION
MANUAL
Pet Trailer/Stroller

Pg. 2
Please retain these instructions for future reference.
SAFETY
WARNING
• Firmly secure all bolts, screws, and knobs before use.
• Reconfirm that all bolts, screws, and knobs are secure every 90 days.
• Do not load more than 66 pounds on this trailer.
• Do not modify the trailer or attach additional loads.
• The maximum allowed speed of the trailer is 10 miles/hour.
• Do not use the trailer on rocky or dangerous roads.
• The trailer is constructed of durable polyester and is coated to be water-resistant.
• Check the air pressure of the tires before every use.
• Make sure that all parts of the trailer are properly connected before every use.
• Be careful when riding in trac and be aware of cars on the road. Slow down on turns and slopes.
• If any parts are missing, broken, damaged, or worn, stop using this item until repairs are made and/or
factory replacement parts are installed.
• Do not use this item in a way inconsistent with the manufacturer’s instructions as this could void the
product warranty.
•Be aware that this trailer can tip over and cause damage to the trailer and/or possible serious injury.
•The following can cause the trailer to tip over:
- Colliding with a road obstruction
- Taking turns at an unsafe speed
- Sudden swerving
- Banked turns
- Improper wheel installation or a loose connection
- Improper air pressure in the tires

Pg. 3
HARDWARE
TOOLS REQUIRED
PARTS
A
E
BC
1 PC
1 PC
2 PCS 1 PC
SAFETY FLAG
1
2 PCS
BRAKE BAR
FORK
BACK WHEEL HANDLE BAR
D
1 PC
FRONT WHEEL
APPROXIMATELY
45 MIN.
ASSEMBLY
1 PERSON
ASSEMBLY
66 LBS
CAPACITY
LBS
SMALL
WRENCH
ALLEN WRENCH
(PROVIDED)

Pg. 4
Replace the metal pin and clip to secure the towing bar in place.
TRAILER ASSEMBLY
Unclip and remove the metal pin from the towing bar underneath the trailer. Unfold the bar so it
is positioned in the front of the trailer.
1
Please retain these instructions for future reference.

Pg. 5
Inside the trailer, lift the metal bar to form the top frame. Secure it to the frame with the attached metal pin
and clip.
Insert the part C handlebar into the trailer. Press the buttons on the sides of the handlebar to adjust it to
your desired position. Compress the metal pins while inserting the handlebar to lock it in place.
2
3
TRAILER ASSEMBLY
C

Pg. 6
Slide on a part B back wheel. Compress the button behind the wheel while inserting and it will lock in place.
Pull on the wheel to make sure it is secure. Repeat on the other side to install the other back wheel.
Remove the bolt on the rear wheel axle of your bike. Place the coupling piece on the end of the towing bar
between the bolt and bike frame, then replace the bolt to secure it in place. Wrap the safety strap around
the frame for added security.
Quick release: Unclip and remove the metal pin from the end of the towing bar to remove the coupling
piece. Leave the coupling piece on your bike so you can easily attach and remove the trailer.
4
TRAILER ASSEMBLY
5
B B

Pg. 7
Insert the part A safety flag into the slot on the left side of the trailer.
In case of rain, pull down and zip the transparent rain protector.
6
TRAILER ASSEMBLY
7
A

Pg. 8
Pull out the front knob on the part E fork, slide in the part D front wheel, and release the knob.
Loosen the two back knobs on the part E fork, slide the fork/wheel onto the front of the trailer, and then
tighten the knobs.
1
STROLLER ASSEMBLY
2
E
D

Pg. 9
Use the front knob on the fork to set the range of motion of the wheel. Turn the knob to LOCK to set the
wheel position in one place. Turn the knob to UNLOCK to allow the wheel to move freely.
To use the hand brake, screw a part 1 brake bar onto the bolt on the side of the trailer near the wheel.
Repeat on the other side. Compress the hand brake to stop the wheels.
3
STROLLER ASSEMBLY
4
1

Pg. 10
If switching to the bike trailer function, remove the fork/wheel and secure it in the designated spot on the
back of the trailer.
5
STROLLER ASSEMBLY

Pg. 11
CARE AND STORAGE
USER WARNINGS AND TIPS
• Clean the fabric with mild soap or detergent and warm water. Use a nylon bristle brush to remove
dicult stains. Do not clean with bleach or abrasive chemicals.
• Wipe trailer dry before storing it.
• Store in a dry and well-ventilated area.
• Avoid storing in direct sunlight.
•Be aware that because of the trailer’s weight, it will take additional time for you to start and stop while on
a bicycle. Make sure to factor in additional time when crossing streets or paths.
•The trailer may only be pulled by a fit and capable adult who has experience riding a bicycle. The adult
must have sound judgement, good eyesight and hearing, and enough strength to pull the trailer.
•Do not cycle or walk with headphones or other distractions. You must be able to hear the surrounding
trac.
•Do not pull the trailer with a motorized vehicle.
•Do not use the trailer o-road or on uneven ground, sand, gravel, ice, oil, or other slippery surfaces. If you
must pass over a slippery surface, walk your bike and trailer.
•Take extra care using this trailer in wet, rainy, or freezing conditions.
•Avoid using this trailer at night or in dark conditions. If you must use the trailer at night, wear reflective
clothing and use bright headlights/taillights.
•Make sure that the wheels are properly maintained.
•Do not replace the tires with high-pressure tires.
•Always use the safety flag to make yourself more visible to motorist and other cyclists.
•Always follow trac laws and local/state bicycling regulations when using this trailer.

ASSEMBLY IS COMPLETE!
All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long as the
item is returned in its original product packaging and all accessories from its original shipment are included. All
returned items will receive a full refund back to the original payment method. All returned items will not be charged
a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best Choice
Products Customer Service Representative when the return request is submitted. Items received without an RA
may not be accepted or may increase your return processing time. Once an item has been received by Best Choice
Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If the
reason for return is a result of an error by Best Choice Products then Best Choice Products will provide a pre-paid
shipping label via email. Boxes for return shipping will not be provided by Best Choice Products, and is the
customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items returned are
not considered undamaged until they are received by Best Choice Products and verified as such. All damages to
items are the customer’s responsibility until the item has been received by and acknowledge by Best Choice
Products as undamaged.
CONTACT US; WE’RE HERE 7 DAYS A WEEK TO HELP YOU!
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
PRODUCT WARRANTY INFORMATION
bestchoiceproducts.com customerservice@
bestchoiceproducts.com 844.948.8400 LEARN MORE!