Beamz LCB99 LED BAR User manual

LCB99 LED BAR
150.711 V1

On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
The unit may be set up on a stable and even surface. By means of the fixing facilities of the baseplate, the unit can also be mounted upside down to a truss,
see below picture. For fixing, certified clamps with correct save working load are required. According to the figure, the quick lock bolts of the omega
brackets are placed into the openings provided in the base plate and turned clockwise until they lock (to the stop). The mounting place must be of
sufficient stability and be able to support a weight of 10 times of the unit’s weight. Secure the unit with a safety cable so that it cannot fall down.
When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let the
installation checked out by an authorized dealer !
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.

A001-Axxx
Auto-run mode
Au1-32
Pre program
FF01-99
Program with hopping effect
CC01-99
Program with fade effect
EE01-99
Program with jump effect
F000-255
Strobe from slow to fast
r000-255
Red manual adjustment
g000-255
Green manual adjustment
b000-255
Blue manual adjustment
u000-255
White manual adjustment
I000-255
UV manual adjustment
Auto
Auto run
SOUD
uoL1-9
Sound sensitivity adjustment
bAon / bAof
Sound mode on/off
1
Master dimmer
000-255
Dimming 0-100%
2
Colour
000-255
Red, 0-100%
3
000-255
Green, 0-100%
4
000-255
Blue, 0-100%
5
000-255
White, 0-100%
6
000-255
UV, 0-100%
7
Strobe
000-009
No function
010-255
Strobe, slow to fast ( CH1 must be on and select the colour CH2 till CH6)
8
Mode
000-010
No function
011-070
Program with hopping effect
071-130
Program with fade effect
131-190
Program with pulse effect
191-255
Sound mode