
Hood / User Manual 15 / EN
4Cleanng and Mantenance
C
Absorbed ar s cleaned by ol fl-
ters and an actve carbon flter and
retransferred to the ktchen. Pc. 4
C
NOTE!
The waste ar should not be trans-
ferred to a smoke or waste gas
flue, nor to a flue used for vent-
laton of the places where heatng
sources are nstalled.
C
To seal the materals causng odo-
ur n the crculatng ar mode, you
should nstall an actve carbon fl-
ter. Consult your authorsed dealer
to learn dfferent opportuntes
for operatng the applance n the
crculatng ar mode. You can buy
accessores necessary for ths
procedure from relevant ponts of
sale, authorsed servce agents or
onlne sales centre.
The applance you have purchased s sutable for
use wth carbon flter. To attach the carbon flter;
1- Place the carbon flter nto ts housng. Pc. 15/1
2- Turn the carbon flter clockwse to make sure
that t s tghtly nserted. Pc. 15/2
C
If the carbon flter s not properly at-
tached, t can fall and damage your
product.
A
CAUTION
Never wash the carbon flters.
Keep the carbon flters away from
chldren.
A
CAUTION
Cleanng and user mantenance
should not be performed by chld-
ren wthout supervson.
•The surface may be damaged due to abrasve
or rubbng cleanng agents. Never use abrasve
and rubbng cleanng agents. Acqure the clea-
nng agents and protectve materals sutable
for your applance form your authorsed servce.
The surface of the applance and the controllers
are senstve to scratchng.
•Clean the surfaces wth a soft and damp cloth,
dshwashng lqud or a soft glass cleanng
agent. Soften the dred and adhered drt wth a
damp cloth. Do not scratch out!
•Dry cloths, sponges that may scratch, materals
that requre rubbng, sand and the other effec-
tve cleanng agents contanng mneral water,
acd or chlorde are not sutable.
•Clean the stanless steel surfaces only n the d-
recton of grndng.
•Do not use stanless steel cleanng agent or wet
cloths for control unts. Cleanng the metal ol fl-
ters Used metallc ol flters hold the humdty
generated n the ktchen and the oly partcles
contaned wthn the steam. In case of regular
use (1 to 2 hours per day), clean the metal ol fl-
ters about once every 3 months.
•Do not use over-effectve, acdfed or corrosve
cleanng agents.
•For the cleanng of the metal ol flters, use a
damp cloth to clean holdng parts of metal ol
flters nsde the applance.
•You can clean the metal ol flters n the dsh-
washer or by hand.
•Do not apply spray cleanng agents drectly on
the applance.
•Do not put flammable and/or heavy decoratve
tems on the applance.
4.1 Washng n the Dshwasher
•In case of washng n the dshwasher, slght ds-
coloraton may occur. Ths does not affect the
functon of the metal ol flter.
•Do not wash heavly soled metal ol flters to-
gether wth the dshes.