Belden FiberExpress Brilliance LC-SC-ST Parts list manual

1. Slide Boot on Fiber 3. Strip off 24 2 mm of Buffer**
4. Mark Buffer at 13 mm 5. Clean Fiber
2. Slide Activator Tab
to the pen Position
Light*MUST
appear
6. Align the end of fiber’s buffer
at 8 mm and cleave
-
+
FiberExpress Brilliance®LC-SC-ST Installation Card
For complete details on this procedure refer to Installation Guide PX105234.
*When using a Visual fault Locator (VFL) during termination.
** When using a field cleaver remove 40 mm of buffer.
A copy of the Guide is supplied with each installation it or visit www.belden.com
BootActivator Tab LC connector
900 μm Buffered Fiber
+0.5
-0.0
0 mm 10 20 30 40 50
813
To Scale
2012 Belden, Inc.
All rights reserved.
Printed in Canada
Document Number: PX105273
Release: F
Date: May 2012
8. Create and maintain a bow
with the fiber, while sliding
the Activator Tab
to the Closed Position
7. Insert Fiber Into Connector up to
the 13 mm Buffer Mark.
Warning: DO NOT try to completely
eliminate residual light
9. Install Boot on Connector
SM - Light*
MUST dim
MM - Light*
MUST go out
ST connector
SC connector

9. Insert jacketed connector
into the Support Handle
10. pen the activator tab and insert
fiber into the connector. Refer to point D
for fiber contact distance.
11. Create a bow and slide the activator
tab to the closed position. Then bring
the boot to the rear of the connector.
12. Unclip the connector then create
another bow of 3 mm and maintain it
until next step.
13. Spread the Kevlar around
the threads then gently screw
on boot and release bow
14. Remove connector and
tighten boot (1/4 turn)
3 mm
7. Clean bare fiber 8. Cleave fiber at
8 mm
+0.5
-0.0
1. Mark jacket at points A and B,
then strip jacket at point A*
FiberExpress Brilliance®LC-SC-ST Jacketed Installation Card
This guide assumes that you have read the instruction manual (PX105234) for the complete installation procedure. This document should be used as a reference only.
2. Cut Kevlar off at point A*
3. Strip jacket at point B*4. Insert boot 5. Ensure fiber is fully pushed into
jacket then mark points C, D and E*
6. Wrap around fingers then
mark and strip off at point C*
15 mm 45 mm
+
15 mm 29 2 mm
+
-
15 mm
7 mm
20 mm
2 mm
Jacket Buffer
Fiber
Point E Point D
Point B Point A
Point C
Quick Reference Diagram (lengths to scale)
Field
Cleaver
Precision
Cleaver