Belkin PAC003 User manual

How to pair the Belkin PAC003 earbuds
How to set the Belkin PAC003 earbuds into pairing mode
Before you can pair your Belkin SOUNDFORM™ Nano Wireless Earbuds for Kids,
PAC003 with your device, they need to be in pairing mode.
Step 1:
Make sure both the earbuds and case are charged. For instructions on how to
charge the Belkin PAC003, click here.
Step 2:
Open the charging case and remove the earbuds from it. The indicator lights on
the earbuds will alternate between blue and white.

You can now proceed with pairing your earbuds using your mobile device. Click
here for specific instructions.
How to unpair the Belkin PAC003 earbuds
The Belkin SOUNDFORM™ Nano Wireless Earbuds for Kids, PAC003 features high
quality sound, supreme comfort and fit, and exceptional durability. The Belkin
PAC003 allows you to control calls and audio playback simply by touch. This also
features touch-sensitive pads that can perform different functions by tapping or
holding on each earbud.

This article will walk you through the steps on how to unpair your earbuds from
your Bluetooth® device.
Step 1:
Turn OFF your earbuds. To do this, you can do either of the two options:
a. Press on both earbuds for 6 seconds.
b. Return the earbuds to the charging case and close the lid.

Step 2:
On your phone or tablet, go to Settings > Bluetooth.
Step 3:
Look for the name of your earbuds. To unpair them, follow the instructions
below:
NOTE: System instructions may vary depending upon your device's operating
system.
For Android™
Go to Settings > Connections > Bluetooth, then select the paired earbuds then
tap Unpair.
For iOS
Go to Settings > Bluetooth, tap the icon on the paired earbuds found under MY
DEVICES and then tap on Forget This Device.
Once you have unpaired your phone or tablet, it will no longer attempt to pair
with your earbuds. You will need to set your earbuds to pairing mode to pair
them again.

How to charge the Belkin SOUNDFORM™ Nano Wireless Earbuds for Kids,
PAC003
The case of the Belkin SOUNDFORM™ Nano Wireless Earbuds for Kids, PAC003
contains a battery that allows you to charge your earbuds without worrying about
finding a power outlet.
This article will show you how to charge the Belkin PAC003. Click on each link
below to learn more.
Charging your earbuds
Charging the case
Charging your earbuds

To charge your earbuds, open the case and place each earbud in its designated
slot then close the lid. If the case has battery power remaining, you do not need
to plug it in while charging your earbuds.
While charging is taking place, each earbud’s indicator light will blink. When the
light indicators stop blinking, this means that the earbuds are now fully charged.

Charging the case
Step 1:
Connect the micro-USB end of the connector to the back of the charging case,
below the lid hinge.
Step 2:
Connect the USB end of the connector to a power adapter or into the USB port of
your computer.

Step 3:
When all lights on the charging case are lit, this indicates that the Belkin PAC003 is
fully charged. The number of lights lit corresponds to the following:
•Four lights –100% charged
•Three lights –75% charged
•Two lights –50% charged
•One light –less than 25% charged