Belkin OmniView Secure F1DN102U User manual

Belkin OmniView® Secure KVM Switch User CC supplement
Belkin OmniView® Secure KVM Switch User Manual F1DN102U F1DN104U F1DN108U Common
Criteria supplement
This section supplements the Belkin Quick Installation Guide in accordance with ADO_IGS.1 Common
Criteria Assurance Measure requirements.
This User Guidance and Common Criteria EAL 4 validation apply to the TOE Common Criteria Evaluated
version of OmniView™ Secure KVM Models listed below:
F1DN102U Version v.321211
F1DN104U Version v.321211
F1DN108U Version v.321211
Before you begin: The Users of the Belkin OmniView™ Secure KVM must review all associated
documentation and guidance, prior to proceeding with installation and use of the KVM switch.
1.1 Receipt and preparation of TOE and Environment prior to installation
Receipt
•Assure that tamper seals are intact on the KVM switch.
Environment preparation
•The Belkin OmniView KVM secure must be located in a physically secure location providing
physical protection and limited (authorized user) access controls.
1.2 Verification of Common Criteria components
The following are authorized devices for the Common Criteria Evaluated configuration. Assure that
installation processes resulting in the following hardware/firmware configuration:
TOE Belkin Secure KVM Switch 2 Port PN # F1DN102U v.321211 (or)
Belkin Secure KVM Switch 4 Port PN # F1DN104U v.321211 (or)
Belkin Secure KVM Switch 8 Port PN # F1DN108U v.321211
(and) Firmware Version 3.16
Environment USB Mouse (Peripheral Group Member)
Environment USB Keyboard (Peripheral Group Member)
Environment Monitor – VGA connector (Peripheral Group Member)
Environment Host Computers Qty 2, 4 or 8 based on KVM used (IT Environment Computer
resources)

Belkin OmniView® Secure KVM Switch User CC supplement
1.3 Usage Assumptions
The Common Criteria Evaluated Configuration requires the following assumptions in usage of the
OmniView Secure KVM device. These assumptions should be assured either through facility or
procedural provisions.
•An AUTHORIZED USER possesses the necessary privileges to access the information
transferred by the TOE.
•USERS are AUTHORIZED USERS.
•The TOE meets the appropriate national requirements (in the country where used) for
conducted/radiated electromagnetic emissions. [In the United States, Part 15 of the FCC Rules
for Class B digital devices.]
•Only the selected COMPUTER’S video channel will be visible on the shared MONITOR.
•The TOE is installed and managed in accordance with the manufacturer’s directions.
•The AUTHORIZED USER is non-hostile and follows all usage guidance.
•The TOE is physically secure.
•Vulnerabilities associated with attached DEVICES (SHARED PERIPHERALS or SWITCHED
COMPUTERS), or their CONNECTION to the TOE, are a concern of the application scenario and
not of the TOE.
2. Common Criteria Administrative Guidance - OmniView® Secure KVM Switch User Manual
F1DN102U F1DN104U F1DN108U
The follow section lists the supplemental information relating to a Common Criteria deployment for the
OmniView® Secure KVM Switch User Manual in accordance with AGD_USR.1 & AGD_ADM.1 Common
Criteria Assurance Measure requirements.
Usage Assumptions
Note that the usage assumptions listed in Section 1.3 must be maintained to assure all TOE security
objectives are maintained during usage.
Applicability of OmniView® Secure KVM Switch User Manual to Common Criteria
The OmniView Secure KVM Switch User Manual applies in its entirety to the Common Criteria Evaluated
Configuration.