Bell 80137-8 User manual

Please read and save these instructions. Please follow the safety and operating instructions carefully. Failure to comply with the
instructions and safety information may result in serious personal injury and/or property damage.
!
WARNING
!
WARNING
• KEEP OUT OF THE REACH OF CHILDREN.
• HOT! Do NOT hold in hand while operating. Place inflator on the ground when in operation.
• NEVER use in traffic or other unsafe areas.
• Do NOT run vehicle while inflator is operating. Engine must be turned off.
• NEVER leave the inflator running unattended.
• NEVER exceed the recommended pressure for any inflatable object. Do NOT over-inflate objects. Over inflation could cause
personal injury and/or property damage.
• ALWAYS use a pressure gauge to check actual pressure.
• For use with any12V DC power outlet rated15-Amps or higher. Do NOT use with older 8-Amp cigarette lighter receptacles.
• Do NOT use inflator for more than10 minutes continuously. Allow the unit to cool for 20-25 minutes between uses.
OPERATING INSTRUCTIONS
Light
12V Power Cord
Pressure
Gauge
Raft Hose
Storage Compartment
Dual On/Off Switch
80137-8
Auto/SUV/Inflatables
Tire Inflator
with Light & Raft Pump

!
WARNING
OPERATING INSTRUCTIONS
TROUBLE SHOOTING
CONTACT INFORMATION
1. Confirm that the power switch on the inflator is in the “OFF” position.
2. Remove valve cap from stem.
3. Attach the universal connector from the inflator to the valve stem with the lever in the “UP” position. Press the lever down to lock
onto the valve stem.
4. Plug power cord into a12V DC power outlet.
For use with any12V DC power outlet rated15-Amps or higher. Do NOT use with older 8-Amp cigarette lighter receptacles.
5. Turn inflator on using the power switch and inflate to the manufacturer’s recommended air pressure.
6. Once desired pressure is reached, turn power switch to “OFF” position.
7. Unplug the power cord from12V DC power outlet.
8. Remove the universal connector from the tire valve.
INFLATOR DOES NOT WORK WHEN SWITCHED TO “ON”
– Power cord may not be plugged in completely. Check the connection.
– Fuse may have blown. Check fuse in plug adaptor and replace if necessary.
UNIT IS RUNNING BUT TIRE IS NOT INFLATING
– Check that the universal connector is attached properly to valve stem.
– Check for tire leaks or damages to tire.
INFLATOR FEELS HOT
– Unit may have overheated. Shut the unit off and allow to cool for 20-25 minutes.
– NEVER use this inflator for more than10 minutes continuously.
QUESTIONS/COMMENTS:
Bell Automotive® Products, Inc.
Attn: Customer Service
18940 N. Pima Road, Suite200
Scottsdale, AZ 85255
www.bellautomotive.com
© 2011 Bell Automotive® Products, Inc.
Bell is a trademark of Bell Sports, Inc.
80137-8-08-1inst.ai