Belnick WX-5L200-BK-GR-GG User manual

WX-5L200-BK-GR-GG /WX-5L200-WH-GR-GG
Thank you for your purchase!
2 Drawer Storage Chest
Customer Service Email: [email protected] | Phone: [phone]
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components
may result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware
(where included) to help prevent the unit from tipping and causing accidental injury, instability, death
or damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult
supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety
Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/WX-5L200-WH-GR-GG.pdf

PARTS
STEP 2
STEP 3
STEP 1
64pcs
4
pcs
2
1
4
4
2
6
6
6
6
10 pc
1
3
7
7
7
3
3pc
1
7pcs
4
10 pc
1
5
5
5
5
5pcs
4
11
1
2
1
3
2
54
2
2
1
2
2
4
4
6
7
8
9
10
11
12
4
Wood
Adjustable leveler
M6X10mm
M6X25mm
STEP 1: Attach Left Frame (Part 1) and Right
Side Frame (Part 2) to the Frame Poles (Part 4)
using (4) M6x25mm Screws (Part 6)
Left Frame
Right Frame
Frame Pole
M6x25mm
Hex Wrench
STEP 2: Place the Wooden
Top (Part 3) with screw holes
facing down and attach to the
frame using (4) M6x10mm
Screws (Part 7)
Wooden Top
Wooden Top
M6x10mm
Hex Wrench
STEP 3: Attach adjustable levelers
(Part 5) to the bottom of the frame
legs and turn clockwise to tighten
Adjustable Leveler

STEP 4
STEP 7
11 pcs
212 pcs 2
11
12
11
11
STEP 5
STEP 6
9
9
8
8
9
Top:Max static weight capacity 40 lbs
Drawer: Max weight capacity 5 lbs
STEP 4: Unfold (2) Fabric Drawers (Part 11) and place Drawer Flooring (Part 12) into the drawer with the pull strap facing up.
Fabric Drawer
Drawer Flooring
STEP 5: Insert drawers into
assembled frame
STEP 6: Insert (2) Wall Anchors (Part 9) into the drywall
Note: A power drill is required to make pre-drilled holes for wall
anchors
STEP 7: Insert Wall Mount Screw (Part 8 through the
hole in the frame and into the Wall Anchors.