BERNSTEIN 805 User manual

Installation guide
Toilet installation system
805
BERNSTEIN
Wellness, Lifestyle & Wohnen

1
Please read this guide carefully before assembling the item!
Items included in the delivery:
Item
Description
Indication
Quantity
Article
Description
Indication
Quantity
Rubber seal
Ø110
1
Rawl plug
SX10 Ø6-8
2
Straight flush
pipe
1
Screw
ST6,8*67
2
Waste seal
1
Washer
Ø22*2,0
2
Eccentric pipe
1
M12 Bolt
2
Rubber seal
1
Screw cover
2
Full flush air
hose
transparent
1
M12 nut
2
Half flush air
hose
blue
1
Washer
Ø32,5*2,5
2

2
Sound
absorbing
panel
1
Rubber bolt
2
Flush pipe
1
Screw cover
2
Rubber seal
for the flush
pipe
Ø60
1
Stainless
steel bolt
2
Rawl plug
8*40
2
Washer
Ø11*1,2
2
Screw
ST4,8*45
2
Items included in the delivery:
Aluminium frame Glass panel Flush valve Inlet valve

3
Lever Flush plate Screw set
Water cistern Lower half frame Drainage pipe

4
Toilet installation system 805
Technical specifications
Product type: wall-hung toilet installation system
Model: 20981 and 20982
Required room temperature: 3 –40° C
Water supply pressure : 0,07 –0,75 MPa
Water temperature: 4 –35° C
Dimension: 1003,5 x 483 x 108 mm
Technical drawings - water inlet and waste system

5

6
Attaching the unit:
1
Insert the drainage pipe into the pre-drilled drainage hole on the wall.

7
2a
Remove the upper cover (1) and the support and the support tube (2).

8
2b
Put the unit into place against the wall and fix the waste pipe (1) with the hose
clamp (2).

9
3
Using a pencil, mark 4 fixing spots on the wall and two fixing spots on the floor
–as indicated by the arrows below –(3).

10
4
Loosen the hose clamp and remove the frame from the wall (4).

11
5
Drill the wall according to the pencil marks. The drilling depth has to be larger
than the length of the rawl plugs, refer to the diameter indicated in the
drawing below (5). Insert the rawl plugs into the corresponding holes (6).

12
6
Position the frame against the wall (7).

13
7
Now fix the unit to the wall tightening the screws in the corresponding rawl
plugs (8) and use the bolts to secure the feet on the floor.
8

14
Connect the tube with the support (1) and the corresponding valve on the wall
(2 + 3).

15
9
Turn and open the valve on the inlet water pipe (4) in order to assess its
functionality.

16
10
Glass panel (4 pieces)

17
Fix the glass panel on the alluminium frame of the unit (1). Press the glass
buckles downwards (2) until they lock on the alluminium frame.

18
12
Install the flush plate frame (1) and the flush plate (2) fixing them to the glass
panel.

19
13
Insert the plugs as shown in the above picture (3).