Opening the Clario®Dispenser:
1. To open the dispenser cover, insert key between
wall and back plate at the bottom of the
dispenser. (Before dispenser is installed, turn
dispenser over and insert key into back plate.)
2. Note: There are two types of keys, one
removable and one permanent. When using
either key, gently push up on the permanent or
removable key until the cover is released at the
top. Once the permanent key is inserted, it
cannot be removed from the dispenser.
CAUTION:
Correct Installation of this unit to ensure
proper function and safety is the responsibility
of the installer. Please completely read and
understand this cautionary note and all
installation or maintenance instructions before
proceeding with installation.
Mounting the Clario™Dispenser
with Anchors and Screws:
1. Using dispenser as a template, mark hole locations
on wall. (To be in compliance with ADA regulations,
the dispenser should be mounted no more than 48”
from the ground.)
2. Drill (4) 3/16” diameter holes.
3. Tap plastic anchors provided into holes.
4. Place screws into anchors and tighten half the
screw length.
5. Hang dispenser over screws using the keyholes in
the back plate of the dispenser.
6. Tighten screws to secure the dispenser.
(Recommended mounting method, anchors and
screws are included.)
12
34
Mounting the Clario®Dispenser
with Double-Sided Tape:
(Double-sided tape should only be used to
secure the unit to smooth, flat, dry surfaces
that do not have chemical residue or
coatings on them. Surfaces should be
thoroughly clean and dry.)
1. Wipe surface with supplied alcohol wipe
immediately before applying tape.
2. (To be in compliance with ADA regulations,
the dispenser should be mounted no more
than 48" from the ground.) Peel off paper from
back of tape. Press dispenser firmly to the wall
and hold for several seconds to make sure tape
has completely adhered to the wall.
3. It is recommended that the dispenser is not
filled with soap for 24 hrs. to ensure that the tape
has completely adhered to the dispenser
before weight is added to the dispenser.
Installing Product into
the Clario®Dispenser
with QCT™Connector:
1. Push valve end of bag down onto the pump
assembly until it clicks and bag is fully pressed down
so pump is inserted completely into the pouch.
2. If needed, gently tuck the corners of the bag to
ensure complete closure of dispenser cover.
56
