BETCO FASTDRAW FOAMER II User manual

KEEP
WEAR
ALWAYS
Please use this equipment carefully and observe all warnings and cautions.
FOAMER II
92216-00
Technical Manual
• Protective clothing and eyewear when dispensing chemicals or other materials or when working
in the vicinity of all chemicals, filling or emptying equipment, or changing metering tips. Use
Betco®FastDraw®products only, use of any other products through the FastDraw®system,
other than products manufactured by Betco®Corporation, will void all warranties and prevent
the system from operating properly.
• Observe safety and handling instructions on the product label.
• Direct discharge away from you or other persons or into approved containers.
• Dispense cleaners and chemicals in accordance with the product label. Exercise CAUTION when
maintaining your equipment.
• Reassemble equipment according to instruction procedures. Be sure all components are firmly
screwed or latched into position.
• Always shut off water and disconnect hose after use. This is a TEMPORARY CONNECTION
NOT FOR PERMANENT INSTALLATION.
• Equipment clean to maintain proper operation.
Package Should Contain
1. FastDraw®Foamer II
2. Instruction sheet

5. Depress trigger to begin dispensing desired concentrate solution; release trigger to stop flow of solution. To lock trigger in "ON" position
depress and hold trigger while sliding red lock button back then release trigger. To release lock push red lock button up and slightly forward
to stop flow of solution.
To disconnect, turn off water source. Make sure on/off valve is in OFF position. ALWAYS DISCONNECT WATER SUPPLY WHEN NOT IN USE!
TRIGGER
5
LOCK BUTTON
5
Installation and Operation
1. Remove FastDraw®Foamer II from box.
2. Connect water supply hose of at least 3/8" ID to water inlet
swivel.
3. Screw cap onto FastDraw®bottle firmly. Do not over-
tighten. Use velcro strap to further secure bottle handle to
dispensing unit.
4. Move product switch to "ON" to dispense product. Switch
to "OFF" to rinse. Rotate front nozzle for jet rinse.
3
ON
4

Parts Diagram List
1 98490-00 Foaming Nozzle Assembly
2 8017-00 Strainer Washer
3 98491-00 Replacement Cap Kit
4 98492-00 Sprayer Assembly (Optional)
5 8025-00 Brass Quick Connect
6 92373-00 Door Replacement
Key Part No. Description
2
1
5
3
4
Problem Cause Solution
1. No discharge a. No water a. Open water supply
b. Valve not open b. Trigger not fully depressed
c. Eductor clogged c. Look for obstruction, remove if possible
d. Foamer/Sprayer pivot not d. Rotate to stops, top or bottom
in proper location
2. No concentrate draw a. Low water pressure a. Minimum 25 PSI (with water running)
required to operate unit properly
b. Switch in "OFF" position b. Switch to "ON" position
3. Failure of unit to turn off a. Trigger lock is on a. Release trigger lock
TROUBLESHOOTING CHART
6

Rev. B 6/21
©2021 Betco Corporation
All Rights Reserved.
400 Van Camp Road
Bowling Green, Ohio 43402
Item #91571-92