Biard BLFL10 User manual

LED SLIM FLOODLIGHT
Contents
Safety InformationPage‑2
Installation Page ‑ 3/4
Warranty InformationPage‑5
Recycling & DisposalPage‑5

2
Other Information
Do not wire this lantern into the lighting circuit ‑ use a switched fuse spur.
This fitting must be earthed. contact a qualified electrician to install a suitable earth facility.
For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mount‑
ing point for this product, before proceeding with the installation.
RISK OF FIRE
Parts required-
Safety Information
Switch off the power while installing.
Do not use this product with a dimmer switch.
We recommend installation is performed by a qualified electrician.
Avoid looking directly into the light when switched on.
Do not modify this product, this will invalidate your warranty.
Read all the instructions in the manual before beginning installation if in doubt use a qualified electrician.
IP65 - For indoor or outdoor use.
Inspect the product for damage before installation.
Please read carefully...
Always switch off the power supply
before Installation or servicing.

3
Isolate the mains power.
Measure and drill x2 mounting holes using the
bracket as a guide ( point A in the image)
Line the bracket up with the mounting holes
and fit the mounting screws to secure in place.
Adjust the light to the desired direction.

4
MAIN CONNECTION-3 CORE PRE-WIRED
Primary 240v 50Hz. Class 1
Connect the BROWN wire to the terminal
marked “L” (Live wire).
Connect the BLUE wire to the terminal
marked “N” (Neutral wire).
Connect the YELLOW/GREEN wire to the
terminal marked E (Earth wire)
Power can now be restored.
THIS PRODUCT COMES WITH AN ADDITIONAL CONNECTION WHICH ENABLES YOU TO CONNECT A
SEPERATE LIGHT SENSOR OR PIR SENSOR (SOLD SEPERATLY).
SEE BELOW FOR ADVICE ON HOW TO ACCESS THIS CONNECTION.
Turn off the power
to the Light.
Unscrew and pull
out the blanking
cap inserted into
the Connection
port.
Offer the connection on the PIR sensor / Light
sensor, push the pins in place and tighten the
plastic nut onto the thread to secure.

5
Warranty Information
• This product is covered by a5 year limited warranty for any manufacturing faults.
• The warranty starts from the date of purchase.
• Labour costs for installation of the Product are not covered under this warranty.
•The warranty is only valid when products are properly installed and operated as speci ied in this manual and the data
sheets.
• All warranty queries should be through the stockist that the product was purchased through.
Recycling & Disposal
The Waste Electrical and Electronic Equipment Directive (WEEE Directive) is the European Community directive
2012/19/EU on Waste Electrical and Electronic Equipment (WEEE) which, together with the RoHS Directive 2002/95/EC,
became European Law in February 2003
The WEEE directive aims to reduce the amount of electrical equipment being produced and to encourage everyone to reuse,
recycle and recover it.
In support of these guidelines and for environmental safety, do not dispose of any electrical equipment including those
marked with the below symbols
When replacing old electrical devices with new ones the retailer is legally obligated to take back your old items for disposal
free of charge. You can also recycle your old electrical devices free of charge at your local recycling centre. Please contact
your local council for more information.
LDG,Unit 1&2,Burnley,BB11 5UB