Big League Lawns CheckMate User manual

1125 Mac Tek Dr C Lansing, MI 48906 800.411.0150
www.bigleaguelawns.com
CheckMate™ Lawn Striping Kit For Snapper 360Z Installation Guide
Important
Big League Lawns, LLC warrants their products to be free of defects in material and workmanship.
This warranty does not cover defects due directly or indirectly to misuse, abuse, normal wear and tear,
failure to properly maintain the product or used for a purpose other than that for which it is intended.
The duration of this warranty is expressly limited to one year parts and labor beginning from the date
of delivery to the original customer.
The obligation of Big League Lawns, LLC is limited solely to the repair or replacement, at our option,
at its factory or authorized repair agent of any part that should prove deficient. Purchaser must
maintain the product under normal operating conditions at all times. Prior to operation, become
familiar with the attachment and any disconnect features. This product is not intended to be used in a
transport position or to be backed over curbs. When not in use, the product should be removed from
the mower and transported in a safe manner. Failure to follow these instructions will void the
warranty.

Mounting Instructions
Snapper 360Z Series Mowers
Congratulations on your new purchase! You are just steps away from creating a beautifully
patterned lawn using your new CheckMate™ lawn striping roller. To ensure a long life of both
your mower and roller, please be sure to follow the mounting recommendations below.
Tools Required:
9/16”Wrench
3/4” Wrench
1/4” Allen Wrench
3/8” Drill Bit
Drill
US Patent 6,962,039 B2, US Patent 6,993,894 B2

Directions
1: You will need to widen your existing holes (Marked on the schematic) to
3/8” to accommodate the provided pivot bolts.
2: Bolt your mounting arms to the circled existing holes on your mower
frame using the provided pivot bolts.
Please utilize Mounting Option D
Mounting Option D
Important: Only the 3/8” threaded portion of your pivot bolt threads pass through the
mower frame. If you are mounting to an oversize hole, please place a 3/8” flat washer
on the pivot bolt threads to prevent the smooth portion of this bolt from passing
through your frame.