Big League Lawns Cub Cadet Pro Z 100 User manual

!
Mounting Instructions
Cub Cadet Pro Z 100/500/700/900
Big League Lawns, LLC - 1125 Mak Tech Dr C - Lansing, MI 48906 - 800.411.0150

"
Step 1: Locate the Mounting Location"
Attach the Quick Release plates to the side framing at the back of the machine. (2) 3/8”
holes will need to be drilled into the machine in order to properly mount the plates. The
two marked red dots below will be your mounting hole locations. (Location
Schematics on next page)
"
Tools Required: For this installation you will need the following tools."
CheckMate™ Hardware
Drill"
(*Depends on
mower.)
3/8” Drill Bit"
(*Depends
on mower.)
1/8” wrench
or socket
and
3/4” wrench
or socket

"
"
Step 2: Mount Plates
Use the hardware included with the Quick Release plates to attach them to
the frame with newly drilled holes (3/8”). Note that when you attach the
Quick Release plates, the stabilizer pins must be facing in the same
direction so that the CheckMate™ striping kit will be able to properly slide
on and offin the same direction."
Big League Lawns, LLC - 1125 Mak Tech Dr C - Lansing, MI 48906 - 800.411.0150
E.G. Both pins facing to the left in this example.
Pro Z 100
Pro Z 500/700/900
Mounting Locations

Step 3: Assemble Hardware "
"
Please refer to the schematic on the next page in order to assemble the
mounting arms. *Note: Only finger tighten the bolts that secure the arms to
the supporting channel piece for now, so that you can center the roller
behind the machine before securing the arms to the channel."
"
"
Step 4: Center the CheckMate™ behind the machine.
Once you have the mounting arms assembled and placed on the roller,
adjust the roller side to side until it is centered behind the mower. Once
you have centered the CheckMate™ striping kit, you can proceed to
tighten the mounting arms to the grey channel piece."
Installation is now complete! Enjoy your striping with your new CheckMate ™ Striping kit!
Big League Lawns, LLC - 1125 Mak Tech Dr C - Lansing, MI 48906 - 800.411.0150
Option A: