Biohort 9003414460416 User manual

LED-Lamp
Thank you for choosing this product.
Read this manual carefully before usage and retain for future reference.
NOTE:
The sensor range is 2-3 meters in the front, and 1-2 meters at the sides.
The sensor effect is related to the temperature and movement speed.
Sensor must not be covered or dirty and should be cleaned.
It must be keept away from dampness, too high or too low temperature and air vent.
The lamp should be fully charged for optimal operation.
The lamp may only be used indoors!
SPECIFICATIONS:
LED Lamp, 60 LED`s, 420 mm lenght
Material: Aluminium shell
500-600 lumen
With motion sensor
Correlated color temperature 6000-6500 K, angle of reective beam 120° grade
Safety class IP20
With magnet for xing on metal and 3M Tape for xing on other materials
Rechargeable battery 2.500 mAh (USB charge)
Including 5 meter USB cabel and USB power adapter
EASY TO INSTALL
Fix the lamp either with the tape or directly with the magnet on metal surfaces.
Back of the lamp Magnetic holder Tape on magnetic holder
Attach the lamp on the holder
with magnet and remove the tape
Fix the light at the position you
want
Additionally, when xed on vertical metal surfaces, we recommend the xation with
the adhesive tape.

40 mm 420 mm
LED
Connector
micro USB
Angle of detection
120° 3 meter
Material
Aluminium / PC
Delay of detection
20 seconds
Three-Mode Switch
Mode 1 (o)
Three-Mode Switch
Cycle
Mode
Mode 2
(Motion sensor)
Mode 3
(Always on)
USB
Switch Button
During the charging process a red
light appears.
When the lamp is fully charged, the
light turns green.
Motion sensor mode:
Click it to turn on the light and into the
motion sensor mode.
Always on mode:
Click it again, get into the always on mode.
O mode:
Finally click it 1s to turn o the light.
16 mm
Biohort GmbH
Pürnstein 43, 4120 Neufelden, Österreich
Phone: [phone], Fax-DW: 190
E-Mail: offi[email protected], www.biohort.com