BIXOLON SRP-350IIOBEi Instruction manual

Bluetooth Connection Manual
SRP-350IIOBEi
Thermal Printer
Rev. 1.00
http://www.bixolon.com

Rev. 1.00
- 2 -
SRP-350IIOBEi
■ Table of Contents
1. Manual Information........................................................................................................3
2. Precautions ....................................................................................................................3
3. iOS MFi Mode Setting (Optional)..................................................................................3
4. Bluetooth Connection Instructions..............................................................................4

Rev. 1.00
- 3 -
SRP-350IIOBEi
1. Manual Information
This Bluetooth Connection Manual provides information on the connection of Bluetooth-
enabled iOS devices with the printer.
We at BIXOLON maintain ongoing efforts to enhance and upgrade the functions and
quality of all our products. In following, product specifications and/or user manual content
may be changed without prior notice.
2. Precautions
2-1 To connect the printer with another device via Bluetooth, the devices must be within
100m of one another. The connection is broken if the distance between devices
exceeds 100m.
2-2 The maximum separating distance may be shortened if transmission obstacles, such
as cement walls, are present.
2-3 If a device (such as a microwave oven, wireless LAN, etc.) that uses the same
frequency is present, transmission may be interrupted. Separate the printer and
Bluetooth-enabled device from such interrupting devices by a distance of at least 5m.
3. iOS MFi Mode Setting (Optional)
This product supports MFi mode that enables Bluetooth communication with iOS devices.
When MFi mode is activated, the printer is not possible to communicate with another
device except for iOS device. (Applicable to MFi Mode support models only: SRP-
350IIOBEi)
3-1 Set-up by printer
1. Turn off the printer power.
2. Remove the screw on the bottom of the printer and
open the bracket.
3. Flip the DIP switches using tweezers or another
narrow-ended tool.
4. MFi mode is available to be changed by setting the
DIP switch NO.8
5. When the DIP switch is on, MFi mode is enabled.
When the DIP switch is off, MFi mode is disabled.
6. The new setting takes effect when you turn on the
printer.
Note: Always change DIP switch settings only when
the printer is turned off. Change made with the
power on have no effect and then on again.

Rev. 1.00
- 4 -
SRP-350IIOBEi
3-2 iOS mode check
1) Implement self-test
2) iOS mode is enabled if “OPERATING MODE” printed “iOS” at the paper.
BLUETOOTH SETTING
BLUETOOTH F/W VERSION: 1.0.00
DEVICE NAME: SRP-350IIOBE
OPERATING MODE: iOS
AUTH. & ENCRY: ENABLE
CONNECTION MODE: 2
3) iOS mode is disabled if “OPERATING MODE” printed “NORMAL” at the paper.
BLUETOOTH SETTING
BLUETOOTH F/W VERSION: 1.0.00
DEVICE NAME: SRP-350IIOBE
OPERATING MODE: NORMAL
AUTH. & ENCRY: ENABLE
CONNECTION MODE: 2
4. Bluetooth Connection Instructions
This manual focuses on the use of the following devices.
Please use this manual as a guide when using devices other than those listed here.
1) Select the icon. 2) Select “General”.

Rev. 1.00
- 5 -
SRP-350IIOBEi
3) Select “Bluetooth”. 4) Select the printer to connect.
5) Enter PIN (default: 0000). 6) Select “Pair”
7) Bluetooth communication is available.