Black & Decker Bright Bar WLB26B User manual

Bright Bar™
INSTRUCTION MANUAL
Catalog Number WLB26B
WLB26B_ManualEN_092707.qxp 9/27/2007 12:22 PM Page 11
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-877-571-2391
BEFORE YOU CALL, HAVE THE CATALOG No,
AVAILABLE. IN MOST CASES, A REPRESENTATIVE
CAN RESOLVE THE PROBLEM OVER THE PHONE.
SAVE THIS MANUAL FOR FUTURE REFERENCE.

• GROUND FAULT CIRCUIT INTERRUPTER (GFCI) protection should be
provided on the circuits or outlets to be used. Receptacles are available having
built in GFCI protection and may be used for this measure of safety.
• USE OF ACCESSORIES AND ATTACHMENTS. The use of any accessory or
attachment not recommended for use with this appliance could be hazardous.
Note: Refer to the accessory section of this manual for further details.
• STAY ALERT. Watch what you are doing. Use common sense. Do not operate
tool when you are tired.
• CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that it will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction manual. Have
defective switches replaced by authorized service center. Do not use tool if
switch does not turn it on and off.
• DO NOT OPERATE portable electric tools near flammable liquids or in
gaseous or explosive atmospheres. Certain components in these tools
normally spark, and the sparks might ignite fumes.
• OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords intended for use outdoors and so marked.
• EXTENSION CORDS. Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. The following table shows
the correct size to use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the gage number, the heavier
the cord.
FETY GUIDELINES / DEFINITIONS
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES
READ ALL INSTRUCTIONS
WARNING: Read all instructions before operating product. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury.
• AVOID DANGEROUS ENVIRONMENTS Don’t use appliances in damp or wet
locations. Don’t use appliances in the rain.
• KEEP CHILDREN AWAY. All visitors should be kept at a distance from work area.
• STORE IDLE APPLIANCES INDOORS. When not in use, appliances should be
stored indoors in dry, and high or locked-up place – out of reach of children.
• USE RIGHT APPLIANCE. Do not use the appliance for any job except that for
which it is intended.
• DRESS PROPERLY. Do not wear loose clothing or jewelry. They can be
caught in moving parts. Rubber gloves and substantial, non-skid footwear are
recommended when working outdoors. Wear protective hair covering to
contain long hair.
• USE SAFETY GLASSES AND OTHER SAFETY EQUIPMENT. Use safety
goggles or safety glasses with side shields, complying with applicable safety
standards and, when needed, a face shield. Also use face or dust mask if
operation is dusty. This applies to all persons in the work area. Also use a hard
hat, hearing protection, gloves, safety shoes and dust collection systems when
specified or required. Safety glasses or the like are available at extra cost at
your local dealer or Black & Decker Service Center.
• DON’T ABUSE CORD. Never carry appliance by cord or yank it to disconnect
from receptacle. Keep cord from heat, oil, and sharp edges.
• DON’T OVERREACH. Keep proper footing and balance at all times.
• DISCONNECT APPLIANCES. Disconnect the appliance from the power supply
when not in use, before servicing, and when changing accessories such as
blades and the like.
• AVOID UNINTENTIONAL STARTING. Don’t carry plugged-in appliance with
finger on switch. Be sure switch is off when plugging in.
1 2
WLB26B_ManualEN_092707.qxp 9/27/2007 12:22 PM Page 1

understand all warnings and operating instructions before using any tool or
equipment.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: This product or its power cord contains lead, a chemical
known to the State of California to cause cancer and birth defect or other
reproductive harm. Wash hands after handling.
WARNING: EXPLOSION HAZARD: Dispose of used batteries properly. Do
not dispose of batteries in fire. This may result in an explosion.
WARNING: FIRE HAZARD: Batteries can explode or leak, and can cause
injury or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the package.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
Never look directly into the light or shine the light into another person’s eyes.
DO NOT expose this unit to extremely high temperatures.
This unit is moisture-resistant, NOT waterproof. Do not submerge in liquids
of any kind.
CAUTION: This unit is intended to be used in a standing or vertical positon.
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY:
• Follow these instructions and those published by the manufacturer of any
equipment you intend to use with this unit. Review cautionary markings on
these products.
SAFETY GUIDELINES/DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous
situation which, if not avoided, may result in property damage.
WARNING: RISK OF UNSAFE OPERATION. When using tools or equipment,
basic safety precautions should always be followed to reduce the risk of
personal injury. Improper operation, maintenance or modification of tools or
equipment could result in serious injury and property damage. There are
certain applications for which tools and equipment are designed. Black &
Decker strongly recommends that this product NOT be modified and/or used
for any application other than for which it was designed. Read and
3 4
Minimum Gage for Cord Sets
Volts Total Length of Cord in Feet
120V 0-25 26-50 51-100 101-150
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V 0-50 51-100 101-200 201-300
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More Not more American Wire Gage
Than Than
0 - 6 18 16 16 14
6 - 10 18 16 14 12
10 - 12 16 16 14 12
12 - 16 14 12 Not Recommended
WLB26B_ManualEN_092707.qxp 9/27/2007 12:22 PM Page 3

USING THE HANGING HOOK
The 360° Swivel Hanging Hook allows you to position the Bright Bar™for
convenient, hands-free operation.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When Hanging Hook is in use, do not shake light.
• When light is hung by the Hanging Hook, do not shake the light or object
that it is hanging from. Do not hang the light from any electrical wires or
anything that it is not secure.
• Only use the Hanging Hook for hanging the Bright Bar™. The Hanging Hook is
not intended to support additional weight. Do not attach or hang anything
additional to the light or risk of breakage may occur.
RECHARGING THE UNIT
Insert the Adapter’s DC Connector of the AC/DC Charging/ Power Adapter into
the 12 Volt DC Charging Port. Insert the plug end into a (powered) standard
North American 120 Volt 60Hz outlet. The red Charging Indicator LED will light
to indicate the unit is charging.
Notes: Do not charge for longer than 8 hours. Charge or powers this unit ONLY
with the originally supplied Class 2 transformer. Consult manufacturer
for replacement.
SAFE BATTERY DISPOSAL
This unit contains a nickel metal hydride rechargeable battery,
which which must be must be disposed of properly when it will
no longer retain a charge. For information on recycling this
battery, call toll-free [phone].
WARNINGS: TO REDUCE THE RISK OF INJURY / EXPLOSION
• Do not dispose of product in fire as batteries inside this product may
explode or leak.
• Do not expose the unit containing a battery to fire or intense heat as it
may explode.
INTRODUCTION
Thank you for purchasing the WLB26B Black & Decker
®
Bright Bar
™
. Please
read this manual carefully before use to ensure optimum performance and
avoid damage to the unit.
FEATURES
• 26 high-intensity LED bright bar illuminates a wide area
• Corded or cordless operation
• Built-in rechargeable Ni-MH battery (with supplied 120 volt AC
Charging/Power Adapter)
• Hi/Low settings extend runtime
• High impact, weather- and shatter-resistant ABS housing
• 360° Swivel Hanging Hook for hands-free use
• Seven hours continuous runtime on Low setting, four hours continuous
runtime on High setting, on a single charge
• Rubber Base allows unit to sit on flat surfaces
OPERATING THE UNIT
Position the unit as desired. Press the HIGH/OFF/LOW Switch on the side of
the unit.
The up position turns the unit ON in HIGH setting.
The down position turns the unit ON in LOW setting.
The center position turns the unit OFF.
OPERATING THE UNIT CORDED
Insert the Adapter’s DC Connector of the AC/DC Charging/Power
Adapter into the 12 Volt DC Charging Port. Insert the plug end into
a (powered) standard North American 120 Volt 60Hz outlet.
Operate the unit as outlined in the previous section.
5 6
WLB26B_ManualEN_092707.qxp 9/27/2007 12:22 PM Page 5