Black & Decker INFRAWAVE FC300 User manual

FC300
www.blackanddecker.ae

ENGLISH
2
Parts Identification
A. Chopper Body
B. Jug
C. Jug Lid
D. Drive Blade
E. Secondary Blade
F. Drive Shaft
D
C
F
E
B
A

3
ENGLISH
Intended use
Your Black & Decker appliance is intended for
chopping and blending soft food. Do not attempt
grinding of nuts, peas and other hard food stuff.
Do not use this appliance for any other purpose.
This product is intended for indoor household
use only.
Read this entire manual carefully
before using the appliance.
Safety instructions
Warning! When using mains-powered
appliances, basic safety precautions, including
the following, should always be followed to
reduce the risk of fire, electric shock and
personal injury.
•The intended use is described in this manual.
The use of any accessory or attachment or
the performance of any operation with this
appliance other than those recommended in
this instruction manual may present a risk of
personal injury.
•Retain this manual for future reference.
Using your appliance
•Always take care when using the appliance.
•Never pull the power supply cord to
disconnect the plug from the socket. Keep
the power supply cord away from heat, oil
and sharp edges.
•Do not place the appliance on or near heat
sources or in a heated oven.
•Do not use the appliance outdoors.
•Always protect the motor unit from water or
excessive humidity.
•If the power supply cord is damaged during
use, disconnect the appliance from the power
supply immediately. Do not touch the power
supply cord before disconnecting from the
power supply.
•Disconnect the appliance from the power
supply when not in use, before fitting or
removing parts and before cleaning.
•Never let the appliance operate unattended.
• Never reach into the jar with your fingers or
an object while the appliance is running.
•Only remove the jar after you have switched
the appliance off and any moving parts have
stopped.
•Do not touch the cutting blades.
•Keep any loose clothing or long hair away
from the feeding tube and any moving parts.
•Care shall be taken when handling the sharp
cutting blades, emptying the bowl and during
cleaning.
•Do not let the cord hang over the edge of a
table, counter, or touch hot surfaces.
•Guide the power supply cord neatly so it does
not hang over the edge of a worktop and
cannot be caught accidentally or tripped over.

4
ENGLISH
Safety of others
•This appliance is not intended for use by
persons (including children) with reduced
physical sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
•Children should be supervised to ensure that
they do not play with the appliance.
After use
•Remove the plug from the socket before
leaving the appliance unattended and before
changing, cleaning or inspecting any parts of
the appliance.
•When not in use, the appliance should be
stored in a dry place. Children should not
have access to stored appliances.
•The unit comes supplied with a non slip
rubber grip. The rubber grip should be
placed under the chopper jar to prevent
slipping during use. The rubber grip can also
be used as a lid for the jar. Ensure that the
rubber is thoroughly cleansed using warm
water and detergent before using it as a lid
or putting it in contact with any food. The
rubber grip, chopper jar and blades are
dishwasher safe.
Inspection and repairs
•Switch off the appliance before cleaning,
changing accessories or approaching parts
which move in use
•Before use, check the appliance for
damaged or defective parts. Check for
breakage of parts, damage to switches and
any other conditions that may affect its
operation.
•Do not use the appliance if any part is
damaged or defective.
•Do not use the appliance if the blade is
damaged.
•Have any damaged or defective parts
repaired or replaced by an authorised repair
agent.
•Before use, check the power supply cord for
signs of damage, ageing and wear.
•Do not use the appliance if the power supply
cord or mains plug is damaged or defective.
•If the power supply cord or mains plug is
damaged or defective it must be repaired by
an authorised repair agent in order to avoid a
hazard. Do not cut the power supply cord
and do not attempt to repair it yourself.
•Never attempt to remove or replace any parts
other than those specified in this manual.
Electrical safety
Before use, check the mains voltage
corresponds to the voltage on the rating plate.
This appliance is double insulated in
accordance with EN 60335-2-14;
therefore no earth wire is required.
•To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in water
or other liquid.
•Check that the supply voltage shown on the
rating plate of the appliance matches that of
your electrical system. Any connection error
will invalidate the guarantee.

5
ENGLISH
Mains plug replacement
If a new mains plug needs to be fitted:
•Safely dispose of the old plug
•Connect the brown lead to the live terminal of
the new plug
•Connect the blue lead to the neutral terminal
•If the product is class I (earthed), connect the
green/yellow lead to the earth terminal
Warning! If your product is class II double
insulated (only 2 wires in the cord set), no
connection is to be made to the earth terminal
• Follow the fitting instructions supplied with
good quality plugs
•Any replacement fuse must be of the same
rating as the original fuse supplied with the
product
Assembly
The appliance should be
disconnected from the mains supply
before assembly.
1. Wash all detachable parts (see chapter
‘Maintenance and cleaning’).
Extra care should be taken when
handling or assembling the blades.
2. Slide the secondary blade onto the drive
blade.
3. Gently twist the secondary blade into place.
4. Place the assembled blade into the jug,
ensure it is placed on to the spindle in the
bottom of the jug.
5. Place the jug lid on to the jug. Ensure that
the spindle of the drive blade sticks out
through the hole in the top of the jug lid.

6
ENGLISH
6. Place the chopper body on to the assembled
jug. Ensure that the spindle of the drive
blade goes into the drive shaft under the
chopper body.
Use
1. Place the appliance on a flat, stable surface.
2. Place the assembled blade into the jug.
3. Place the ingredients into the jug.
4. Place the jug lid onto the jug.
5. Place the chopper body on to the assembled
jug.
6. Connect it to the electricity supply.
7. Press down on the chopper body to start the
appliance.
The appliance should be
disconnected from the mains supply
before removing from the jug.
The appliance will not operate
without the jug lid fitted.
Do not operate the appliance without
the drive blade fitted.
Do not operate the appliance without
the secondary blade fitted.
The chopper should not be run for longer than
60 seconds. After a continuous run of 60
seconds, the chopper should be allowed to cool
for at least 5 minutes before further use.
Useful advice
• Place the appliance on a clean, flat work
surface.
Note: Do not exceed the maximum capacity of
0.5 litres.
•When chopping is complete disconnect the
appliance from the power socket.
•Once the blades have come to a complete
stop, lift the chopper body from the jug.
Remove the lid and blades then pour the
ingredients into a suitable container.
•After use the cable of the appliance can be
wrapped around the top of the chopper body
for storage.
Recommended run time
Onion 10 240g cut into
quarters
Garlic 3 150g whole
peeled cloves
Ginger 3 150g cut into
thumb sized pieces
Carrot 4 150g cut into
thumb sized pieces
Meat 25 350g cut into
2cm cubes
Ice cubes 37 10 ice cubes
Food Run Time Comments
(Seconds)

7
ENGLISH
Maintenance & cleaning
•Switch the appliance off, remove the plug
from the power socket and wait until the
blade has stopped rotating.
•The appliance is easier to clean if you do so
immediately after use.
•Do not use abrasive cleaning agents,
scourers, acetone, alcohol etc. to clean the
appliance.
•All detachable parts are dishwasher-safe.
•Place the detachable plastic parts on the top
tray of the dishwasher. Make sure they are
placed well away from the heating element.
•All removable parts can be cleaned with a
cleaning brush in warm water with some
washing-up liquid and rinse them under the
tap.
•Remove the dirty parts from the motor unit.
Clean the motor unit with a damp cloth.
Never immerse the motor unit in water nor rinse
it under the tap.
Technical data
FC300
Voltage 220 – 240 Volts
Supply 50/60 Hz
Power consumption 500 W
Weight 1.04 kg

Protecting the environment
Separate collection. This product must not
be disposed of with normal household
waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
other household waste. Make this product
available for separate collection.
• Black & Decker provides a facility for
recycling Black & Decker products once they
have reached the end of their working life.
This service is provided free of charge. To
take advantage of this service please return
your product to any authorised repair agent
who will collect them on our behalf.
• You can check the location of your nearest
authorised repair agent by contacting your
local Black & Decker office at the address
indicated in this manual. Alternatively, a list of
authorized Black & Decker repair agents and
full details of our after-sales service and
contact are available on the Internet at:
www.2helpU.com.
Warranty
Black & Decker is confident of the quality of its
products and offers an outstanding warranty.
This warranty statement is in addition to and in
no way prejudices your statutory rights.
The warranty is valid within the territories of the
Member States of the European Union and the
European Free Trade Area.
If a Black & Decker product becomes defective
due to faulty materials, workmanship or lack of
conformity, within 24 months from the date of
purchase, Black & Decker warranty to replace
defective parts, repair products subjected to fair
wear and tear or replace such products to ensure
minimum inconvenience to the customer unless:
The product has been used for trade,
professional or hire purposes;
The product has been subjected to misuse
or neglect;
The product has sustained damage
through foreign objects, substances or
accidents;
Repairs have been attempted by persons
other than authorised repair agents or
Black & Decker service staff.
To claim on the warranty, you will need to submit
proof of purchase to the seller or an authorised
repair agent. You can check the location of your
nearest authorised repair agent by contacting
your local Black & Decker office at the address
indicated in this manual.
Alternatively, a list of authorised Black & Decker
repair agents and full details of our after-sales
service and contacts are available on the Internet
at: www.2helpU.com.
8
ENGLISH

Parts Identification
A. Corps du hachoir
B. Bol
C. Couvercle du bol
D. Lame d’entraînement
E. Lame secondaire
F. Axe d’entrainement
D
C
F
E
B
A
9
FRENCH

10
FRENCH
Utilisation prévue
Votre appareil Black & Decker est conçu pour
hacher et mixer des aliments mous. Ne tentez
pas de moudre des noix, des pois ou d’autres
aliments durs.
Ne pas utiliser cet appareil à d’autres fins.
Cet appareil est destiné à un usage domestique
uniquement.
Lisez ce manuel attentivement avant
d’utiliser l’appareil.
Consignes de sécurité
Avertissement! Lorsqu’on utilise un appareil
électrique, il faut toujours respecter certaines
règles de sécurité fondamentales, notamment
les suivantes, afin de prévenir les risques
d’incendie, de décharges électriques et de
blessures corporelles.
•Ce manuel décrit la manière d’utiliser cet
appareil. L’utilisation d’un accessoire ou
d’une fixation, ou l’utilisation de cet appareil à
d’autres fins que celles recommandées dans
ce manuel d’instruction peut présenter un
risque de blessures corporelles.
•Conservez ce manuel pour un usage
ultérieur.
Utilisation de votre appareil
•Prenez toutes les précautions nécessaires
pendant l’utilisation de l’appareil.
•Ne tirez jamais sur le cordon d’alimentation
pour débrancher la fiche de la prise. Gardez
le cordon d’alimentation éloigné de toute
source de chaleur, de zones graisseuses et
de bords tranchants.
•Ne placez pas l’appareil sur ou près de
sources de chaleur ou dans un four chaud.
•N’utilisez pas l’appareil à l’extérieur.
•Protégez toujours le bloc moteur de l’eau ou
d’une humidité excessive.
•Si le cordon d’alimentation est endommagé
pendant l’utilisation, débranchez
immédiatement l’appareil. Ne touchez pas au
cordon d’alimentation avant d’avoir
débranché l’appareil.
•Débranchez l’appareil de l’alimentation
secteur lorsqu’il n’est pas utilisé, avant de
monter ou de démonter des pièces et avant
de le nettoyer.
•Ne laissez jamais fonctionner l’appareil sans
surveillance.
•Ne mettez jamais vos doigts ou tout autre
objet dans le bol lorsque l’appareil est en
cours de fonctionnement.
•Retirez le bol uniquement après avoir éteint
l’appareil et patienté jusqu’à l’arrêt complet
des parties mouvantes.
•Ne touchez pas les lames de coupe.
•Tenez les vêtements amples ou les cheveux
longs à l’écart de la cheminée de
remplissage et des parties mouvantes.
•Faites attention lors de la manipulation des
lames coupantes, en vidant le bol et pendant
le nettoyage.
•Ne laissez pas le cordon pendre au bord
d’une table, d’un comptoir ou être en contact
avec des surfaces chaudes.
•Positionnez soigneusement le cordon
d’alimentation et veillez à ce qu’il ne pende
pas du plan de travail pour éviter de l’attraper
par mégarde ou de trébucher dessus.