BLOTZ B10-MW-112 User manual

10mm 5x1 Mixed Foyer
B10-MW-112
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B10-MW-112)
Start by removing the sections shown above
(right) from the sprue. There are enough parts to
create all four doorway sections.
Glue them together as shown in the image on the
left.
Glue the doorways to the back of the long sides using
the lugs/holes provided.
At the same time glue a triangular bracer to the
back of the long sides at each end. Leave these to
dry.
Glue the two end walls into place then add the
decorative columns.

10mm 5x1 Mixed Middle
B10-MW-157
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B10-MW-157)
Remove the four walls and four rectangular
supports from the sprue. Glue one support to
the bottom rear of each wall (as shown above).
At the same time glue two triangular corner bracers
onto each of the short walls as shown. Allow to dry.
Glue the long walls into place.

10mm 5x1 Mixed Roof
B10-MW-207
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Roof Section (B10-MW-207)
Remove the four walls and four rectangular
supports from the sprue. Glue one support to
the bottom rear of each wall (as shown above).
Allow to dry.
Glue the four wall pieces to the roof.
Finally glue the decorative pieces above the windows.