BLOTZ B06-CS-010 User manual

6mm Dubai Skyscraper
B06-CS-010
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Remove the “roof”pieces shown above from the
sprue.
Glue the walls to two of the pieces as shown above.
Glue them to the back of one of the uprights as
shown.
Glue the supports into position (with the “T”side
towards the roof). Add the other side piece.
Take the rear wall and inner windows.
Glue the windows into place, ensuring the bottom is
flush with the base of the building. This leaves a small
gap at the top end.
Glue the rear wall into place.
We suggest you paint your building at this point.
Spray the main building silver and do a drybrush of
light blue over it (see following pics).
The outer skin can be sprayed white with the details
picked out in Black / Blue.

The painted inner core of the building.
More detail of the inner core of the building.
The outer skin of the building.
Glue these around the building as shown.