BlueSky Designs Mount'n Mover User manual

move it
mountnmover.com
quick guide
This guide describes the basics of setting up your Mount’n Mover
so that it stops at, moves from, and returns to any desired posi-
tion. For further assistance, please call us at 888-724-7002, or
check out our website for more detailed instructions.
a: Release “red lock” by rotating clockwise
b: Unlock by pulling out & up on handle (highlighted orange)
c: Lift off by pulling forward and up
Reverse these steps to re-attach to device plate
attach it - detach Quick Release Plate (QRP)
- reattach QRP
- attach device to device plate
- move shoulder & elbow joints
- rotate wrist joint
- change tilt-plate angle
attach to quick release plate
attach device to appropriate device plate
Slide LEVER to the right to
unlock the tilt-plate
Position the tilt-plate to the
desired orientation
Slide the LEVER to the
left to lock the tilt-plate
Depress PADDLE to release
the wrist lock
Move it
Wrist will remain unlocked
until it reaches lock position
a
b
c
Push tool into slot until the
shoulder joint releases
Rotate shoulder until desired
orientation is achieved
Remove tool & wiggle joint
until shoulder locks
Locate friction set screw on each joint
Insert a 1/16” hex key
Turn hex key to the right
to increase or to the left
to decrease joint friction
±5° increments
attach
it
move
it
adjust
it
mount
it
set it
step 1
step 2
initial setup
ne tune
friction adjustment
Depress HOOP to unlock
elbow & shoulder joints
Move It from lock position
To nd lock position
release downward
pressure on hoop and
move until arm stops
set it To set custom lock positions:
Align set-screw with desired lock
position and slide lock tab down
Flip up all lock tabs so joints move
freely with no lock positions
You cannot unset a lock tab with
the set-screw directly above it
Orient to best t user needs;
move set-screw to nearest lock tab;
slide lock tabs down to set locks

mount it
adjust it
Use our Round Clamp for mounting
vertically to round tubing
Our Bridge Clamp provides a
stable mounting solution for
most chairs with round tubing
- step-by-step instructions and mounting options are available at: www.mountnmover.com
- periodically check that all screws are tight
1/4-28 threads 1/4-20 threads (T-nut only)
a, b, & c - post should be vertically oriented for the user’s typical upright position (dashed line in a)
d- slots in clamp & post must align
e- post clamp pressure should be set so that, when clamped, the post is held tightly and securely
f- post height set screw ensures repeatable height & safety
Quantum tiedown
Permobil Unitrack
Post is correctly aligned when the
post and clamp slots are aligned
Flip the plate for more
angles (every 7.5°)
To adjust post angle (± 5°)
1. Loosen the post angle screw
2. Release clamp lever
3. Rotate post until vertical
4. Tighten the post angle screw
5. Lock clamp lever
+
-
Post alignment
Clamp pressure
slot
slot
Solid Wheelchair Bracket
Frame tubing with through holes
optional
Back plate has 4 orientations
Bridge Clamp
Angle Adj. Plate
Adjustable Wheelchair Bracket
T-nut & screws
(supplied) have
1/4-20 threads
Storm / TDX & Quantum track
Quick Guide rev. 2, 10-26-12
ab
c
d
f
e
Round Clamp
Channel captures
lock nuts
Post height