Bond HYUTT10001-4 User manual

Owner’s Manual
Potrero Table-Mount FireBowl
Item#
Model# HYUTT10001-4 DANGER
WARNING
WARNING
If you smell gas:
1. Shut off gas to the appliance.
3. If odor continues, keep away from
the appliance and immediately call
Do not store or use gasoline or other
vicinity of this or any other appliance.
An LP-cylinder not connected for use
shall not be stored in the vicinity of
this or any other appliance.
For outdoor use only.
Save these instructions for future use. If
you are assembling this unit for someone
else, give this manual to him or her and
read and save for the future.
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the owner’s manual thoroughly before installing or servicing this
result causing property damage, personal injury or loss of life.
Note: A table with an umbrella hole (not included)
is required to assemble this product.
50225

Bond Manufacturing Company | Page 2
WARNING
Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so
may result in a re, explosion, injury or death.
SAFETY INFORMATION
• Do not use this rebowl for cooking.
• Do not burn any other materials than are supplied with and intended for use in this rebowl.
• Do not pour water into rebowl.
• The installation of this product must conform with local codes or, in the absence of local codes,
with either the National Fuel Gas Code, ANSIZ223.1/NFPA 54, or CAN/CGA-B149.1, National Gas and
Propane Installation Code. *Do not use this rebowl if any part has been under water.
• Do not store a spare or disconnected propane cylinder under or near this rebowl.
• After a period of storage, and/or non use, the propane rebowl should be checked for gas leaks and
burner obstructions before use.
• Do not operate the propane rebowl if there is a gas leak present.
• Never use a ame to check for gas leaks.
• Combustible materials should never be within 48 inches of the top, back or sides of your propane
rebowl.
• Do not put any other rebowl cover or anything ammable on, or beneath the rebowl.
• The propane rebowl should never be used by children. Children must be supervised when they are
anywhere near the appliance.
• Users should be alerted to the hazards of high surface temperatures and keep a safe distance to
avoid burning or clothing ignition.
• Pay attention when operating the rebowl. It is hot when in use and should never be left unattended.
Do not transport it while in operation.
• Should re go out while burning, turn the gas valve off. Wait ve minutes before attempting to relight,
then follow instructions to light the rebowl.
• Never use charcoal or any other solid fuel in the rebowl. Never place clothing or other ammable
materials on or near the rebowl.
• Never lean over the open rebowl or place hands or ngers on the upper portion of an operational
unit.
• Keep ventilation openings in cylinder enclosure (FIREBOWL BODY) free and clear of debris.
• Do not rest feet on the rebowl.
• Do not enlarge valve orices or burner ports when cleaning the valve or burner.
• Propane gas is not natural gas. Only use propane for this rebowl.
• The conversion or attempted use of natural gas in a propane unit.
• Do not use this rebowl on vehicles or boats. Always operate the appliance on at ground outdoors.
• Keep any electrical supply cord and the fuel supply hose away from any heated surfaces.
• Do not use this rebowl unless all parts are in place.
• Inspect the burner before each use of the appliance. If there is evidence of damage, the burner must
be replaced prior to the appliance being put into operation. Use Manufacturer approved or supplied
replacement burner only.
• FOR PROPANE GAS UNITS: The gas pressure regulator provide with the propane re bowl must be
used.
• Do not attempt to disconnect the gas regulator or any gas tting while your rebowl is in operation.
• A dented or rusty propane cylinder may be hazardous and should be checked by your gas supplier
prior to use.
• Do not use a propane cylinder with a damaged valve and any other worn out parts.

1-866-771-2663 | Page 3
• Transport and store the empty gas cylinders carefully and properly.
• If you see, smell or hear the hiss of escaping gas from the propane cylinder: 1. Disconnect propane
gas cylinder, 2. Do not attempt to correct the problem yourself, 3. Get to your gas supplier and/or the
re department for help.
• Any guard or other protective device removed for servicing this re bowl must be replaced prior to
operating this appliance.
• The maximum supply pressure is the 250 psi.
• This appliance is designed for use with a 16.40Z (1Lb) propane gas cylinder (disposable). The
propane cylinder must be constructed and marked in accordance with the specications for Gas
cylinders of the U.S. Department of Transportation (DOT) or the National Standards of Canada, CAN/
CSA-B339, cylinders, Spheres and Tubes for Transportation of Dangerous Goods;and Commission,as
applicable.
• Cylinders must be stored outdoors in well-ventilated area out of the reach of children.
• Disconnected cylinders must have valve caps tightly installed and must not be stored in a building or
any other enclosed area.
• Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before
igniting.
• Pumice stones/lava rocks/LavaGlass™could hit somebody’s face or eyes during initial start of this
unit, so please keep away from the rebowl for the rst 20 minutes after it has been ignited.
• During Ignition procedure, one should NEVER get his/her face close to and or above the burner. In
case of the unnoticed ame may suddenly be lit up and causing injury.
• Children should never operate this unit. Children must be supervised while near this unit.
• All installation and repair should be done by a qualied professional. This unit should be
inspected annually and cleaned regularly.
• Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of the appliance.
• Clothing or other ammable materials should not be hung from the appliance or placed on or
near the appliance.
• Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
• Installation and repair should be done by a qualied service person. The appliance should be
inspected before use and at least annually by a qualied service person. More frequent cleaning
may be required as necessary. It is imperative that the control compartment, burners and
circulating airways of the appliance are kept clean.
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond
Manufacturing at 1.866.771.2663.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned “OFF” before assembling. Do NOT attempt to assemble without proper tools.

Bond Manufacturing Company | Page 4
Combustible materials should not be within 48
inches of the top of the unit, or within 48 inches
around the entire unit.
SAFETY INFORMATION
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
A table with an umbrella hole (not
included) is required to assemble
this product; shown to the right is
an example of a table with an
umbrella hole.

1-866-771-2663 | Page 5
Item Description Qty
A
Body
1
B
LavaGlassTM
C
Control Knob (preassembled)
1
D 1
CONTENTS
E
Support ring
1
F
Regulator
1
1
1
2
1.54lb
A
D
C
B
E
F
G
G
Glass Tube
1
B
H
I
J
H
I
J
M4xL8mm screw
M6xL60mm screw
Fixing ring
MMM666xxxLLL666000mmmmmm ssscccrrreeewww
Fixing bracket

Bond Manufacturing Company | Page 6
ASSEMBLY INSTRUCTIONS
1. Remove the support ring (C) from the body (B).
Insert the body (B) through the umbrella hole in
the table.
2.
B
C
I
F
H
3.
2 and secure the body (B) on the table top.
B
D
B
4. Attach the regulator and valve (D) onto the body (B) by
screwing it into the bottom of the threaded outlet.

1-866-771-2663 | Page 7
5. Place the bag of LavaGlassTM renrubehtotno
)J
(
evenly.
the body (B).
J
A
B
4. Place the glass tube (A) onto the supports in
3. Check that the control knob (E) for the gas
supply system is turned to the “OFF” position
before starting any assembly.
To attach the 1 lb. propane gas tank (not included)
on the unit, screw the 1 lb. gas tank to the
E
D
D

Bond Manufacturing Company | Page 8
OPERATION
•Before performing any maintenance always disconnect propane gas tank.
•Keep the heating item free and clear from combustible materials.
•Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
•Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner and pumice stones/
lava rocks/LavaGlass™ are completely cooled down. Wipe down with a soft cloth.
•Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
•Permanent damage may occur if powder or solvent comes in contact with painted or plastic
components on this heating unit.
•Keep the heating unit stored away from direct sunlight.
•If storing this unit inside, disconnect the propane gas tank from the gas valve.
•Not using manufacturer approved or supplied parts/accessories may result in a defective condition
and void the warranty of this heating unit.
•Always place lid (if applicable) or protective cover on heating item when not in use.
To Light
To Extinguish
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the “off”
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles
occur on any connection there may be a leak. If you smell gas or a leak is discovered turn the
gas valve off, disconnect propane gas tank and do not use the appliance until the leak is
repaired.
Pumice stones/lava rocks/LavaGlass™could pop up and strike somebody’s face during the process
should be a yellow/blue color between 1 - 7.5 inches in height.
heating item.
1. After assembling the gas tank, push and turn the control knob (C) counter-clockwise, then use a
2.
1. Turn the control knob (C) clockwise to the ‘off’ position.
2. Disconnect propane cylinder to close the gas supply if not using for a period of time.
MAINTENANCE

1-866-771-2663 | Page 9
TROUBLESHOOTING
Problem Cause Solution
No gas flow Check if gas cylinder is empty
Regulator isn’t connected securely to the
tank
Tighten regulator connection to the gas
tank
Spider webs or insect nest in the burner
and guard
Check the burner and guard
Burner ports are clogged Turn all gas flow connections off. Insert
an opened paperclip (or similar item) into
each of the burner ports to clear them
out.
Heating unit emits a lot of
black smoke
Flame is obstructed at burner ports Check that all burner ports are free of
any small lava rocks/pumice stones/
LavaGlass™ pieces
High or gusting winds Increase flame to ‘high’
No gas flow Check if gas cylinder is empty
Burner won’t light with
a match
Flame blows out
easily
Envirostone™Surface Care
Our Envirostone™ material has been sealed with a patented treatment to prevent staining and
moisture absorption, but it does require proper maintenance to ensure the integrity of the surface.
Please see below for recommendations on maintaining your Envirostone™ surface for years of
pleasure:
• Clean any spills immediately to prevent permanent Envirostone™ surface staining or damage.
Blot any liquid spills with a clean, dry cloth to avoid spreading of the spill to the rest of the table.
Clean your Envirostone™ surface with a soft, clean cloth or sponge. Mix a solution of warm clean
water and mild dish soap to remove any surface dirt or mild spills. Rinse all soap solution off of the
tabletop and dry completely to avoid water spots. Regularly cleaning the Envirostone™ surface will
aid in a longer lasting product.
• Do not use petroleum-based or abrasive cleaning products. Do not use any harsh brushes when
cleaning the Envirostone™ surface.
• Do not slide products across the Envirostone™ surface to avoid permanent scratching and
damage.
• Always use protective mats such as coasters or placemats when eating on an Envirostone™
surface. These protective products will help absorb sweating on cool beverages and will block
out any heat rings from appearing beneath a warm mug or plate. When placing hot dishes on an
Envirostone™ surface, always use mats or hot pads.
• Envirostone™ surface must be covered at all times when not in use. Cover your product with an
outdoor furniture cover when not in use to protect it from the elements. Store your product indoors
during winter months. Avoiding extreme cold temperatures will prevent cracking of the tabletop.

Bond Manufacturing Company | Page 10
WARRANTY
If you have any questions or concerns, please contact Bond Manufacturing Company at the below
resources:
CONTACT
Toll Free Phone [phone]-BOND (2663) | Monday - Friday, 8am - 4:30pm PST
Email customer[email protected]
Online www.bondmfg.com
The manufacturer warranty will be voided by, and manufacturer disclaims any responsibility for, the
following actions:
•Modication of the unit and/or components including the gas valve assembly.
•Use of any component part not manufactured or approved by Bond Manufacturing.
•Use and installation other than what is listed in this manual.
Please contact the manufacturer for replacement parts.