Bond PGF6501-1 User manual

PLATINUM PORTABLE GAS FIRE PIT
Owner’s Manual
Item#
Model# PGF6501-1
52251 DANGER
WARNING
WARNING
FIRE OR EXPLOSION HAZARD
If you smell gas:
Shut off gas to the appliance.
Extinguish any open flame.
If odor continues, leave the area immediately.
After leaving the area, call your gas supplier
or fire department.
Failure to follow these instructions could
result in fire or explosion, which could cause
property damage, personal injury, or death.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance. An LP-cylinder not connected
for use shall not be stored in the vicinity of
this or any other appliance.
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury, or loss of life.
•
•
•
•
DANGER CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed
space such as a camper, tent, car or
home.
INSTALLER: Leave this
manual with the appliance.
CONSUMER: Retain this
manual for future reference.
or the gas supplier.
by a qualified installer, service agency,
Installation and service must be performed
WARNING:For Outdoor Use Only.
service agency, or the gas supplier.
with this appliance. Installation and service must be performed by a qualified installer,
damage, personal injury or loss of life. Refer to the owner's information manual provided
Improper installation, adjustment, alteration, service or maintenance can cause property

Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so
may r
WARNING
•
•THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a
ventilated space and shall not be used in any enclosed area.
•This unit is to be used with propane gas only! (sold separately)
•Do not attach a remote gas supply to this unit.
•Only use propane gas for this unit.
•Solid fuels shall not be burned in this appliance.
•
•LP GAS WARNING: Do not use any more than 1/4in depth lava rocks/pumice stones/LavaGlass®
above the bur
•If the propane gas tank is leaking gas, you may hear, see, or smell a hiss. Do the following:
e department for help.
•Applying too much propane may result in gas pooling and will not burn. Allow fresh air into the unit
so that the remaining gas may escape.
•
•
•
•You must use a propane tank that has a collar to protect the gas valve.
•
•The tank system must be set up for vapor withdrawal.
•Discontinue use if any part of the propane tank is damaged. Rust and dents may be hazardous and
should be inspected by a gas supplier.
•
•
rocks/pumice stones/LavaGlass®could pop out and cause injury. Should any rocks pop out, discard
them.
•Always ensure that lava rocks/pumice stones/LavaGlass®are completely dry before use. Failure to
do so will cause them to crack or pop.
•Do not operate unit until all parts are fully assembled.
•Do not paint or color any part of this heating unit.
•Unit may be hot while in use, do not attempt to move it while in use.
•Never leave this heating unit unattended while in use.
•This unit is not intended for cooking.
•
•Keep a safe distance to avoid burning skin or clothing.
•Do not sit or rest hands or feet on this heating unit.
•
•Keep all electrical cords and fuel supply hose away from heated surfaces.
Use LP propane tanks with the following dimensions: diameter 12 in, height 18 in - capacity 20 lbs.
The installation of this unit must adhere to local codes or Propane Storage and Handling Code,
CSA B149.2.
Manifold pressure: 11 inch w.c. (2.74 kPa).
SAFETY INFORMATION
Bond Manufacturing Co., Inc. | Page 2

• Combustible material should not be within 72 inches of the top of the unit, or within 48 inches
around the entire unit.
• Keep the appliance area clear and free fr
vapors and liquids.
•
•Do not add water into the unit.
•Do not operate unit if any part has been under water. Immediately call a qualied service technician
to inspect the appliance and replace any part of the control system and any gas control that has been
under water.
•Do not disconnect any part while unit is in use.
•Do not store a spare propane tank on or near this unit.
•If the heating unit is indoors, detach the propane tank and leave outdoors.
•Always remove protective cover before operating (if applicable).
•Do not set the protective cover over the unit until it is turned off and completely cooled down.
•Check for leaks after not using the unit for long periods of time.
•Children should never operate this unit. Children must be supervised while near this unit.
•Keep gas tank at least 5 feet away from unit when lit. (if external tank)
•Maximum gas supply:250 psi; Min. gas supply:10 psi.
inspected annually and cleaned regularly.
•Inspect all elements of this heating unit before each use. If there is damage, the burner must be
replaced.
•Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)
•Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or
injury.
of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas
tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission.
gas tank connection.
•Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
•Young children should be carefully supervised when they are in the area of the appliance.
near the appliance.
•Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
(CGA791) LP
• DO NOT use heating item while lid is installed. Always remove the lid while heating item is in use.
• Allow heating item to cool completely before placing on lid.
IF APPLICABLE:
45 minutes to cool down before touching or moving the fire pit.
• FOR YOUR SAFETY: Surfaces of the fire pit can remain extremely hot for a period after use. Allow
circulating airways of the appliance are kept clean.
may be required as necessary. It is imperative that the control compartment, burners and
•This heating appliance should not be used on wood, plastic or artificial wood decks.
1-866-771-2663 | Page 3

Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Combustible materials should not be within 72
inches of the top of the unit, or within 48 inches
around the entire unit.
valve is turned 'OFF'before assembling. Do NOT attempt to assemble without proper tools.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co., Inc.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, call Bond
Manufacturing Co., Inc. at 1.866.771.2663.
SAFETY INFORMATION
Bond Manufacturing Co., Inc. | Page 4
Always place this outdoor fire pit
on a hard, level,
non-combustible surface such as concrete, rock or
stone.
Propane tank must be a minimum of 60 inches
away at all times.
DANGER
60 IN

BBAA
QtyDescriptionItem
M6 x 16 ScrewAA
BB
Before beginning assembly of this product be sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part appears to be missing or damaged do
not begin assembly of this product and call customer service immediately.
Estimated assembly time: 5 minutes
Tools required for assembly (not included): Phillips Screwdriver
Washer 2
2
HARDWARE
1-866-771-2663 | Page 5

A Lid
I
Control Knob (preassembled)
Electronic Igniter (preassembled)
J
Guard (preassembled)
Burner (preassembled)
Battery (AA)
B
B
F
D
C
E
A
G
H
J
I
Item Description Qty
Body 1
C Handle 1
1
D
Tank holder 1
E
Pumice Stones 1 box
F
1
G
H
1
1
1
1
(3.5 kg)
CONTENTS
Bond Manufacturing Co., Inc. | Page 6

washers (BB) and 2 pcs M6 x 16 screws (AA).
igniter cap (H) over the battery tightly.
(H) by unscrewing and slide battery (D) into the
Check that the control knob (G) for the gas
Attach handle (C) to the lid (A) using 2 pcs
AA
C
BB
2.
G
before starting any assembly.
supply system is turned to the 'OFF'position
1.
OFF
ON
OFF
ON
3. Remove the rubber cap on the electronic igniter
battery slot. Make sure the positive side of the
battery faces outwards. Screw the electronic
H
D
ASSEMBLY INSTRUCTIONS
1-866-771-2663 | Page 7

Please inspect the rubber O ring in the propane
tank valve to ensure it is not worn before attaching
regulator from the body to the cylinder valve by
4. Put the 20 lb. propane gas tank (not included)
into the tank holder (E). Turn the wing screw on
the outside of the tank holder (E) clockwise to
tighten the tank into the tank holder.
E
Propane tank must be a minimum of 60 inches
away at all times.
DANGER
Cover body (B) with lid (A). To lock lid
(A) in place, turn clockwise. To unlock, turn
counterclockwise.
A
B
6.
ASSEMBLY INSTRUCTIONS
Bond Manufacturing Co., Inc. | Page 8
RUBBER O RING
REGULATOR
BLACK COUPLING NUT
turn clockwise to connect
CYLINDER VALVE
PRESSURE
RELIEF VALVE
BLEED-OFF
VALVE
turn clockwise
to reseal
explosions and serious injury by propane tank.
regulator. Worn rubber O ring can cause leaks,
Turn the cylinder valve on the tank clockwise to
close the propane tank. Attach the preassembled
turning the regulator coupling nut clockwise.
Make sure it is fastened securely and tighten
connections by hand only.
5.
WARNING

burner should be free of pumice stones at all
To ensure proper function, the guard (I) on this
F
B
I
Place pumice stones (F) into body (B).
times.
7.
Keep away from the unit and allow the unit to
burn 20 minutes for the first time use.
Always ensure that lava rocks/pumice stones/
LavaGlass®are completely dry before use. Failure
to do so will cause them to crack or pop.
WARNING
1-866-771-2663 | Page 9
ASSEMBLY INSTRUCTIONS

Push and turn the ignition control knob (G) clockwise to the
G) either clockwise or counterclockwise
Push the ignition control knob (G) in and turn counterclockwise to
Turn ignition control knob (G) to the
Fire product and propane gas cylinder minimum
distance must be over 60 inches (as per right side
photo)
WARNING
To Light
1. ‘OFF’position. Connect propane gas tank to regulator
and open the cylinder valve.
2. the ‘HIGH’position; this
will ignite the fuel.
3. If ignition does NOT immediately take place in seconds, push and turn the ignition control knob
(G) clockwise to ‘OFF’. Wait 5 minutes, then repeat the lighting procedure as above.
4.
heating item.
Wait 50 minutes after extinguishing ame prior to placing a lid (if applicable) or protective cover on
20 minutes after igniting. Flame should be a yellow/blue color and between 2 - 10 inches in height.
strike somebody’s face during the process of lighting this unit; stand away from the unit for the first
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass®could pop up and
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion
off, disconnect propane gas tank and do not use the appliance until the leak is repaired.
on any connection there may be a leak. If you smell gas or a leak is discovered turn the gas valve
position. Brush a soap and water mixture on all connections. Turn the gas supply on; if bubbles occur
area. Connect the propane gas tank to the regulator and turn the valve on the unit to the
‘OFF’
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
the propane gas tank.
2. Turn the propane gas tank valve on the gas tank to close the gas supply and disconnect
1. ‘OFF’ position.
To Extinguish
Bond Manufacturing Co., Inc. | Page 10
OPERATION
WARNING
If the burner does not ignite with the burner
control valve open, gas will continue to flow
out of the burner and could accidentally ignite
causing injury or property damage.
OFF
ON
OFF
ON
60 IN