Bose ControlSpace ESP-88 User manual

ControlSpace™ESP-88 GPIO card
1. Turn off and unplug the ESP-88 and detach the top cover by removing the 8 screws.
2. Remove the bracket farthest to the right by unscrewing its two screws (save these screws).
The GPIO card will replace this bracket. See Figure 1.
3. Attach one end of the ribbon wire to the GPIO connector.
4. Position the GPIO card in the chassis and screw the card into place. See Figure 1 and Figure 2.
Figure 1 Figure 2
Installation should only be performed by trained service personnel.

©2006 Bose Corporation, The Mountain Framingham,
MA 01701-9168 USA
AM299788 Rev.00
pro.bose.com
5. Attach the free end of the GPIO ribbon wire to the available connector located beside the first GPIO card connector on the motherboard.
See Figure 3.
6. Reattach the top cover and fasten the 8 screws. Plug in the power supply and turn on the ESP-88.
7. Use the ControlSpace™ designer software to verify the card was inserted correctly:
a) Press scan and confirm that the software detects the card.
b) If the card was installed correctly, right-clicking the ESP-88 and displaying its properties will show that GPIO usage is in slot 1 and slot 2.
See Figure 4.
8. If an error message appears, or the software does not properly detect the GPIO card, repeat the installation instructions. Be sure that the
ribbon wire is completely pushed into both connectors.
Figure 3 Figure 4
For installation instructions in other languages, please visit pro.bose.com.