Operating Instructions
Power Supply
Transmitter: A23 attery, 12 V
Switching receiver: 240 V~, 50 Hz
Max. Resistive Load:
Switching receiver ON/OFF: 3120 Watt / 13 Ampere
Buttons on t e Switc ing Receiver:
Large utton on the front of the housing: ON/OFF
Small utton on the ottom of the housing: Learn
the coding
Learning t e Codes:
1. Push »Learn«- utton for 2 seconds so that the
green indicator lamp on the front illuminates and
the receiver is in learn mode.
2. Then push the ON utton A of the transmitter to
allocate one of the channels of the remote con-
trol to this receiver.
3. As soon as the receiver has received the valid
code from the transmitter, the display illuminates
3 times to indicate that the code is stored.
4. The learn mode takes approx. 8 seconds, after
which the learn mode has finished, the indicator
is off and the switching receiver is ready for op-
eration.
5. The codes are permanently stored, also if the
switching receiver is not connected to the mains.
6. There are 16.777.216 different codes availa le for
the system that can e attri uted at random.
7. To program further switching receivers, do steps
1 - 4 again with the channels B - C.
3
Instructions manual