Brickcom OSD-200A 20xp Datasheet

2 Megapixel Speed Dome
Network Camera
OSD-200A 20xp
Easy Installation Guide

1
Step 1. Check Package Contents
a. Network Camera
b. M3 Standard Screw (x1)M3 Security Screw (x1)
M5 Standard Screw (x1)
M5 Security Screw (x1)
Security Torx
Lubricant
c. Waterproof Rubber
d. Power
Connector
Alarm I/O
Connector
Audio
Connector
e. Outdoor Mount
Kit
f. Easy Installation
Guide
g. Product CD
h. Warranty Card
English

2
<Bottom View>
Please refer to the illustrations below to
connect power core through the supplied
power adaptor, and set up the audio
according to the Audio pin definition.
<Power Connector>
<Audio Connector>
NOTE: To power up the camera, please plug the AC 24V cable into the camera’s
power connector (Operating Temperature: -40℃-50℃); Or connect the Ethernet
cable to the camera’s Ethernet port and plug the other end of cable into an IEEE
802.3at High Power over Ethernet (PoE plug)switch (Operating Temperature: -7℃
-50℃)

3
<Alarm I/O Connector>
When cabling, please refer to the table below for pin definition of Alarm I/O setting.
Please make sure the alarm connections are properly.
Step 2. HW Installation
1. Apply lubricant to the Dome cover’s water-proof rubber to make the installation
process smoother.
NOTE: The tiny protrusion on the dome cover must align with one of the four holes
on the dome body.

4
2. Attach the Dome cover to the Dome body by gently pressing down on the sides of the
Dome cover with both hands.
NOTE: DO NOT press the cover from the top as this may cause damage to the
Dome body.
3. Screw the Dome cover and body together.
Step 3. Install Camera with Mount Kit.
1. Make a cable entry hole on the wall/ ceiling to insert the cable(s).
2. Attach the waterproof rubber to the selected mount kit.
3. Route the Ethernet and I/O cables through the top holder and join the selected mount
kit with supplied screws and washers. Then adjust the Waterproof Rubber over the
joint.
4. Connect the Ethernet and I/O cables and hook the safety wired to the camera.
5. Attach the camera to the top cover with the supplied screw and washers.

5
Wall Mounting: Pendant Mount (mounting example)
NOTE: Refer to the mounting instruction in the “Speed Dome Mounting Accessories
Installation Guide” for more details.

6
Step 4. Install the EasyConfig Software
Insert the CD into the CD-ROM, and follow the instructions of the Install Shield Wizard to finish
installation.
Step 5. Launch EasyConfig
Launch the EasyConfig software, and click on the camera from the survey list to connect.

7
Step 6. Installation Completed
Click <Live View> to view the live video feed of the network camera.
Enter the default user name (admin) and password (admin) in the prompt request dialogue.
After connecting to the network Speed Dome Camera, the request for installing the ActiveX control
will appear below the URL bar. Right click on the bar, and click “Install Brickcom ActiveX Control..”to
permit ActiveX control installation.
In the pop-up security warning window, click “Install”to start downloading DC Viewer software on the
PC.
Click “Finish”after DC Viewer installation is complete.