Brickcom VD-E200Af series Datasheet

Easy Installation Guide
Megapixel Day & Night
Vandal Dome Network Camera
VD-E200Af
VD-E200Nf
English

Package Contents
Please check to make sure the product package contains all the accessories
listed below.
A. Network Camera
B. Product CD
C. Allen Key
D. Screw Bag
E. Easy Installation Guide
F. Alignment Sticker

Hardware Installation
WARNING: Do not mount the camera on a soft material. The camera
may fall and be damaged.
Step 1. Camera Installation
A. Use the enclosed Allen key to detach the dome cover from the
camera device.
B. Hammer the three plastic anchors which are provided in the product
package into the three location holes. The user needs the three
screws which are included in the product package and a screwdriver.
Mount the camera on the wall or ceiling and position the three screw
slots over the plastic anchors. Insert the screws into the holes and
use the screwdriver to tighten the screws clockwise until they are
secure.

Step 2. Camera Connection
The camera is DC12V and PoE compliant, so there are two options for
connecting the camera to a power and Ethernet source. The camera can
either be connected to a PoE-enabled switch or a non-PoE switch.
A. If using a PoE-enabled switch:
Use an Ethernet cable to connect the camera to the PoE-enabled switch.
B. If using a non-PoE switch:

i. Use an RJ-45 cable to connect the camera to a PoE Injector.
ii. Use an RJ-45 cable to connect the PoE Injector to the non-PoE
switch.
iii. Use a standard power cable to connect the PoE Injector to a
power outlet.
C. If using the DC12V power Supply. The RJ45 cable will be for data
transmission.
Step 3. Complete the Installation
Place the dome cover back on the camera device using the Allen Key.

Software Installation
Step 1. Install the EasyConfig Software
Insert the CD into the CD-ROM, and follow the instructions of the
InstallShield Wizard to finish installation.
Step 2. Launch the EasyConfig Software
Launch the EasyConfig software, and click on the camera from the survey
list to connect.

Follow the EasyConfig software to configure the camera’s IP address and
EasyLinkTM settings.
Step 3. Installation Completed
Click to view the live video feed of the network camera.