1. Software Resources..........................................................................................................................1
1.1 Driver......................................................................................................................................1
1.2 Arduino IDE.......................................................................... Error! Bookmark not defined.
1.3 EasyPrint 3D Installation and Configuration..........................................................................2
2. Hotbed Leveling...............................................................................................................................5
2.1Homing.....................................................................................................................................5
2.2 Coarse Tuning of distance between the nozzle and the hotbed...............................................6
2.3 Fine Tuning .............................................................................................................................7
3. Print Settings....................................................................................................................................8
3.1 Quick mode.............................................................................................................................8
3.2 Custom mode ..........................................................................................................................9
3.2.1 Create a new configuration/setting ...............................................................................9
3.2.2 Print settings................................................................................................................10
4. Begin Printing................................................................................................................................21
4.1 Load a Model File.................................................................................................................22
4.2 Print Setting...........................................................................................................................22
4.3 Slicing ...................................................................................................................................23
4.4 Stand-alone print with SD Card............................................................................................24
4.4.1 Save Job ......................................................................................................................24
4.4.2 Print.............................................................................................................................25
5.FAQ ................................................................................................................................................27
5.1 How to upgrade firmware? ...................................................................................................27
5.2 How to change the motor direction in firmware?.................................................................30
5.3 User manual of Repetier Host...............................................................................................31
5.4 Possible causes for motor’s non-action.................................................................................31
5.5 Extruder does not work normally..........................................................................................31
5.6 The hotbed or extruder can not be heated.............................................................................31
5.7 LCD error: MAX/MIN TEMP error .....................................................................................31
5.8 No information or displaying black square on LCD.............................................................31
5.9 Time.h/endstop hit or other abnormalities ............................................................................31
