!
!
9
!
!
ASSEMBLY OF THE TRAMPOLINE
!
1. Position all the parts on the floor checking the inventory.
2. Assemble all the circular tubes together in order to make a large circle.
3. Place the leg extensions B into the U-shaped feet A.
4. Attach the feet/leg extensions to the circular structure using screws O1 & washers O2.
Note: the 2 middle holes on each side are meant for fixing the safety net poles with the O3
key.
5. Put the jumping mat I inside the structure with the brand logo towards the sky and tie it with
a spring D into one of the mat’s buckle joint and the other side of the spring into the circular
structure. Use the spring tool E to attach the springs. Repeat this step by adding a spring right
in front of where you added the first one. You should spread the tension of the springs by
always placing them one in front of the other and spacing them by 2 or 3 springs. It is very
important to respect this process to avoid the structure being bent.
6. You can now add the protective mattress H over the springs. It is reversible so you have a
choice of colours between blue/black or orange/apple green. To avoid dismantling your
trampoline, please choose beforehand your favourite colour.
This protective mattress is attached to the structure by inserting a spring in each strip of the
mattress. Use spring tool E to untie the already set springs and place them inside the strips
and attach them again to the structure.
1. Jumping mat
2. Protective mattress over the springs with strips
3. Spring
4. Circular metal structure
7. You can now verify your trampoline. It should look like this.
8. Assemble the tubes/poles F and G together and insert the protective foams over the low
and up poles. Repeat for each tube/pole.
9. Fix each pole to the base structure using 2 screws P1 into tube G and on the other side,
add the plastic wedge P4, washer P2 and nut P3. Screw and tighten.
10. Once this step is accomplished, remove your shoes and step on the trampoline to add
the poles’ caps on top of each pole. The poles’ caps => part L if you have an inside net and
part M if you have an outside net.
TRAMPOLINE CLASSIC - inside net
10.1. The strings attached to the top of the net are to be inserted into the L cap to fix the
safety net. Tighten them all.
10.1. Attach the bottom of the safety net with the provided string J. You have to pass it through
the net and through the structure of the jumping mat. Tighten everything.
10.1. Scratch the brand Velcro on top of the net.
TRAMPOLINE DELUXE - outside net
10.2. Put on the safety net sleeves over the poles. Start with the first 40cm for each pole and
then come back to the first sleeve to bring them down by 20cm more and so on.
10.2 Secure the bottom of the safety net with the attached clamps. Fix them to the jumping
mat’s buckles. The safety net has to go over the protective pole foams G.
10.2. Scratch the brand Velcro on top of the net.
