Bunn ThermoFresh SERVER Quick reference guide

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with MECHANICAL SIGHT GAUGE
STEP 2
Place a cup or container in
center of serving platform
as indicated.
STEP 4
STEP 3
Open the faucet handle
until the desired quantity is
dispensed.
STEP 1
The server must be placed
on a sturdy counter or
shelf.
NOTE: Bunn-O-Matic recommends the three step method for cleaning and sanitizing the server. The 3 step method consists
of hot soapy water using an mild, non-citrus detergent, a fresh water rinse and an aqueous sanitizing solution using a non-
chlorine sanitizer. Do not submerge the server. Failure to follow the recommended cleaning procedures can cause
corrosion to the stainless steel surface and damage the vacuum seal. USE OF ANY CHLORINATED PRODUCT VOIDS THE
FACTORY WARRANTY.
Do not submerge server.
39483.0008A09/16 ©2014 Bunn-O-Matic Corporation
BEVERAGE DISPENSING
STEP 3
Rinse server thoroughly
using fresh water rinse.
Fully fill server with sanitiz-
ing solution for 5 minutes
then drain throughfully open
faucet.
STEP 1
Run a complete brew cycle
of hot water into the server
and let it set for a minute.
Empty the server
completely by opening the
faucet.
STEP 2
Flip the lid, fill server with
cleaning solution and
thoroughly clean the inside
of server.
DAILY CLEANING
RELEASED FOR PRODUCTION
DIR Num: 39483.0008 22, January 2019

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with MECHANICAL SIGHT GAUGE
STEP 9
STEP 8
STEP 5
Remove the faucet handle/
stem assembly by unscrew-
ing the faucet nut.
Disassemble the faucet/
stem assembly. Thoroughly
wash all faucet parts, drip
tray and cover in a mild
detergent and water solu-
tion. Rinse the parts in hot
water. Sanitize the parts for
five minutes, then air dry
completely.
DAILY CLEANING (Continued)
Remove the drip tray and
drip tray cover. Thoroughly
wash in a mild detergent
and water solution. Rinse
the parts in hot water.
STEP 6
Push sight gauge cap up
and pull tube from the
shroud. Remove the
grommet from the tube
and clean thoroughly.
STEP 10
Reassemble the faucet and
attach it to the dispenser.
CAUTION: When
reassembling, DO NOT
over-tighten faucet
bonnet. Hand tighten only.
STEP 11
Wash the entire outside
surface of the server with
a soft, non-abrasive cloth.
Do NOT clean with a water
jet device.
STEP 7
Wash the entire outside
surface of the lid assembly
with a mild detergent, water
solution, and a soft, non-
abrasive cloth and rinse
with hot water.
Do not submerge.
RELEASED FOR PRODUCTION
DIR Num: 39483.0008 22, January 2019