Bunn ThermoFresh SERVER Quick reference guide

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with DIGITAL SIGHT GAUGE
STEP 1 STEP 2 STEP 3 STEP 4
STEP 1
Place a cup or container in
center of serving platform
as indicated.
STEP 2 STEP 3 STEP 4
39483.0002A 04/08 ©2008 Bunn-O-Matic Corporation
Open the faucet handle
until the desired quantity is
dispensed.
The Server Cover needs to
be removed to fill the Server
when brewing from a Bunn-
O-Matic®Dual TF DBC or
Single TF DBC or ICB coffee
brewer.
DAILY CLEANING
Remove the lid, fill server
with cleaning solution and
thoroughly clean the inside
of server.
Runacompletebrewcycleof
just hot water into the server
and let it set for a minute.
Emptytheservercompletely
by opening the faucet.
When proper precautions
are followed, 1.0 up to 1.5
gallons of coffee may be
brewed directly into the
server and then transported
toa remoteservinglocation.
Theserver must be placed on
a sturdy counter or shelf.
NOTE: Bunn-O-Matic recommends the 3 step method for cleaning and sanitizing the server. The 3 step method
consists of hot soapy water using an approved detergent, a fresh water rinse, and an aqueous sanitizing solution
using an approved non-chlorine sanitizer. Do not submerge server.
BEVERAGE DISPENSING
Rinse server thoroughly us-
ing fresh water rinse.
Fully fill server with sanitiz-
ing solution for 5 minutes
thendrainthroughfullyopen
faucet.

USE & CARE INSTRUCTIONS for ThermoFresh®SERVER
with DIGITAL SIGHT GAUGE
STEP 6 STEP 7STEP 5
STEP 9
STEP 8
Remove the faucet handle/
stem assembly by unscrew-
ingthefaucetnutjustbehind
the faucet handle.
STEP 10
Disassemble the faucet/
stem assembly. Thoroughly
wash all faucet parts, drip
tray and cover in a mild
detergent and water solu-
tion. Rinse the parts in hot
water. Sanitize the parts for
five minutes, then air dry
completely.
Wash the entire outside sur-
face of the lid assembly with
a mild detergent and water
solution and rinse with hot
water. Do not submerse.
39483.2 042408
Reassemble the faucet and
attach it to the dispenser.
Wash the entire outside
surface of the server with a
clean damp cloth. Do NOT
clean this equipment with a
water jet device.
DAILY CLEANING (Continued)
Usecleaning brushsupplied
withtheserver tothoroughly
clean the fill tube of the lid
assembly and the faucet
spout.
Remove the drip tray and
drip tray cover. Thoroughly
wash in a mild detergent
and water solution. Rinse
the parts in hot water.