BURG-WACHTER Point Safe Electronic Series User manual

www.burgsecurity.com.au
Point Safe
Electronic Series
OPERATING INSTRUCTIONS
(HOTEL MODE)

CONVERTING SAFE TO HOTEL MODE
Open the safe door - with the door open press the [CLOSE] button so that the
locking bars are extended (out of door).
Press [ENTER] – “CODE” appears in display.
Enter master code (pre-selected 1-2-3-4-5-6-7-8) and press [ENTER] again.
“PASS 1, PASS 2, PASS 3 … PASS 0” appears in display.
Before this count is finished press [ENTER] again - “CODE” appears in display.
Enter the code “16805” and press [ENTER] – “SET-05” appears in display.
In “Hotel” mode if the door remains open for more than 5 minutes, a user code
has to be entered again.
CONVERTING SAFE TO HOME MODE
Open the safe door - with the door open press the [CLOSE] button so that the
locking bars are extended (out of door).
Press [ENTER] – “CODE” appears in display.
Enter master code (pre-selected 1-2-3-4-5-6-7-8) and press [ENTER] again.
“PASS 1, PASS 2, PASS 3 … PASS 0” appears in display.
Before this count is finished press [ENTER] again - “CODE” appears in display.
Enter the code “16800” and press [ENTER] – “SET-00” appears in display.
In “Home” mode the user code will not reset even if the door is left opened.