BURG-WACHTER Universal Safe User manual

Universal Safe
Catalogue No. U 2 E
OPERATING INSTRUCTIONS

Universal Safe - U2E
OPERATING INSTRUCTIONS FOR SAFE &
ELECTRONIC CONTROL PANEL
IMPORTANT:
Please keep your keys in a secure place, but not in the safe.
Keep your personal code secure.
Do not use personal data (eg: birthdays, telephone numbers etc).
HOW TO OPEN THE SAFE WITH THE KEY:
Remove the cap that is located between the knob & keypad on the front of the
safe.
Insert the key & turn it anti-clockwise. Then turn the knob clockwise & open the
door.
HOW TO INSTALL THE BATTERIES:
Remove the plastic cover from the box located on the inside of the safe door.
Insert 4 x AA batteries, 1.5v (Alkaline).
HOW TO PROGRAM YOUR PERSONAL CODE:
Open the door
Press and release the RED button on the inner side of the door jamb and the
GREEN control light on the front of the safe will light up.
Enter your personal code. (3 - 6 digits).
Press the ENTER key to store your new code.
HOW TO OPEN THE SAFE USING THE KEYPAD:
Press the ENTER key.
Enter your personal code.
Press the ENTER key.
After the melody you can open the door with the knob (turning clockwise).
HOW TO CLOSE THE SAFE:

Universal Safe - U2E
Close the door & turn the knob anti-clockwise.
BATTERY INDICATOR:
The batteries should be replaced immediately if the RED light comes on.
After having replaced the batteries the personal code must be re-programmed.
ALARM IN CASE OF WRONG CODE:
After the third incorrect code the opening mechanism is blocked for 2 minutes.
After this time has elapsed the safe can be opened with the correct code.
INSTALLATION:
The safe can be installed by securing to a wall or the floor with the masonry
bolts provided.