C & K Systems SpreadNet SN962-PENDANT User manual

Model SN962-PENDANT
Two Button Panic
Installation Instructions
Modelo SN962-PENDANT
Dos Botones de Pánico
Instrucciones de Instalación
Remove the Battery Activator Tab from the positive
(+) end of the battery.
Saque la etiqueta para activar la batería por el lado
positivo (+).
Connect the SN900-PROG RF Programmer to the
Molex®connector.
Use the SN900-PROG to select the appropriate
system (Sierra®, Multi-Zone, or Single Zone). Program
the Pendant according to the instructions listed in the
SN900-PROG Programming Manual (PN 5-051-136-00).
Conecte el programador RF SN900-PROG al conector
Molex®.
Usando el SN900-PROG, seleccione el sistema que esté
usando (Sierra®, Multi-Zona o Zona Única). Programe el
Pendant de acuerdo a las instrucciones especificadas en
el Manual de Programación para el SN900-PROG
(PN5-051-136-00).

!
Remove screw from back cover, open the
Pendant with a screwdriver as shown.
Saque el tornillo de la tapa de atrás, abra el
Pendant con un destornillador.
1
2

C & K is a registered trademark of C & K Components, Inc.
Sierra and SpreadNet are registered trademarks of C & K Systems, Inc.
All other trademarks are the property of their respective owners.
Copyright1999C&KSystems,Inc.
FCC NOTICE
The Model SN962-PENDANT Two Button Panic generates and uses radio
frequency energy. If not installed and used in accordance with the
manufacturer's instructions, it may cause interference to radio and televi-
sion reception. The Pendant Transmitter has been tested and found to
comply with the specifications in Part 15 of FCC Rules for Class B
Computing Devices and FCC Part 15 Subpart C, Specifications for Inten-
tional Spread Spectrum Radiators.
Ifthisequipmentcausesinterferencetoradioortelevisionreception-which
can be determined by turning the equipment on and off - the installer is
encouraged to correct the interference by one or more of the following
measures: 1) Reorient the antenna of the radio/television. 2) Connect the
AC transformer to a different outlet so the control panel and radio/television
are on different branch circuits. 3) Relocate the control panel with respect
to the radio/television.
If necessary, the installer should consult an experienced radio/television
technician for additional suggestions, or send for the "Interference Hand-
book" prepared by the Federal Communications Commission. This booklet
is available from the U.S. Government Printing Office, Washington D.C.,
20402, stock number 004-000-00450-7.
CAUTION: C & K does not support field changes or modifications to any of
the SpreadNet RF equipment unless they are specifically covered in this
manual. All adjustments must be made at the factory under the specific
guidelinessetforthinour manufacturingprocesses. Anymodification tothe
equipment could void the user's authority to operate the equipment and
render the equipment in violation of FCC Part 15, Subpart C, 15.247.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Industry Canada
This device complies with RSS-210 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
SPECIFICATIONS
• Dimensions:
8.4 cm x 5.25 cm x 1.9 cm
(3.31" L x 2.06" W x 0.75" D)
•Weight:
57 g (2 oz.)
• Operatingfrequency:
902-928MHzSpreadSpectrum
• SupervisoryRate:
30 - 300 sec (10 sec intervals)
0 is unsupervised
• Inputpower:
one 6 VDC 1/2AA lithium battery
• Outputpower:
10mW maximum
transmitting period - 7.6 mSec
• Replacebatteriesonlywith:
C & K Model # SN60L-BAT
Duracell XL PX 28L
• Operatingenvironment:
0° to 60° C (32° to 140° F);
up to 95% relative humidity
(non-condensing)
• RFemissionstandards:
USA: FCC Part 15
FCCCertificationNumber: C2DLWSN-61-KF
CANADA: IndustryCanada
ICCertificationNumber: 1140102615
DESCRIPCIONESDETALLADAS
• Tamaño:
8.4 cm x 5.25 cm x 1.9 cm
•Peso:
57g
• Frecuenciadeoperación:
902-928MHzSpreadSpectrum
• Intervalo de Supervisión
30-300seg(intervalos de 10 seg.)
0essupervisado
• Entradadecorriente:
uno 6 VDC 1/2AA batería
• Rendimientodepoder:
10 mW máximo
tiempo de transmisión- 7.6 mSec
• Sereponenlasbateríasunicamente con:
C& K número demodelo SN60L-BAT
Duracell XL PX 28L
• Ambientedeoperación:
0° to 60° C;
hasta95%humedadrelativa
(nocondensar)
• RFnormasde emisiones:
E.E.U.U.: FCC Parte 15
FCCCertificationNumber: C2DLWSN-61-KF
CANADA: IndustriaCanada
ICCertificationNumber: 1140102615
IMPORTANT NOTES
Batteries should be replaced following a low battery indication
or every 3 years, whichever occurs first.
For continued reliability, the SN962-PENDANT should be
tested at least once per month.
NOTAS IMPORTANTES
Las baterías se deben reponer después que se vea la
indicación de batería baja o cada 3 años, según lo que suceda
primero.
Para que alcance un rendimiento mejor, el SN962-PENDANT
se debe probar una vez por mes.
US Patents 4,977,577; 5,067,136; 4,581,606 PCT/US95/
02690;5,457,713PCT/US95/04731;5,265,120;08/560,304;
5,408,217; and 5,119,396
P/N 5-051-562-00 RevB http://www.cksys.com