C.P. Electronics Rapid EBR-4SC User manual

RAPID Scene Select Plate
EBR-4SC User Guide
The EBR-4SC provides advanced scene seng funcons for the Rapid Lighng Control System.
When used in conjuncon with Rapid dimming LCMs and suitable dimming luminaires, complex
dimming can be achieved to suit applicaons from conference rooms to individual oces. This
product provides for the selecon of scenes and the programming of LCMs to provide set dimming
This device should be installed by a qualied electrician in accordance with the latest edi-
on of the IEE wiring regulaons.
Installation
Key
1. brown
2. brown/white
3. green
4. white/blue
5. blue
6. white/green
7. orange
8. white/orange
Operating
To select a scene press the requisite
button (press and hold to get scenes 5 to 8
To raise the light level
To lower the light level
To turn the lights off
(Scene 0 - reserved as
the “off” scene, but can
be programmed to
leave a background
lighting effect.)

Ref: #WD243 Issue 5
C.P. Electronics Ltd
Brent Crescent
London
NW10 7XR
United Kingdom
Tel: + 44 (0) 333 900 0671
Fax: + 44 (0) 333 900 0674
www.cpelectronics.co.uk
IMPORTANT NOTICE!
This device should be installed by a
qualified electrician in accordance with
the latest edition of the IEE wiring
regulations.
Due to our policy of continual product improvement CP Electronics reserves the right to alter the specification of this product without prior notice.
Enter programming mode by pressing
the following sequence of buttons within
5 seconds.
All LEDs will flash to indicate the scene
plate is in programming mode.
Choose the scene number to
program. Press and hold the requisite
button to get scenes 5 - 8.
To confirm the selection press:
Choose the circuit ID this applies to (do
this even if the circuit ID is the same as
the scene number). Press and hold the
requisite button to get circuit ID 5 - 8.
To confirm the selection press:
Set the required light level for this
circuit:
Repeat steps 4 and 5 for all circuits
required.
To cancel the current values and revert
back to the stored setting, press:
To store the scene setting repeat step 1
above.
If no keys are pressed for more than 5
minutes, you automatically exit
programming mode and no changes are
saved.
1
65
4
3
2
Programming
Technical Data
Supply voltage DC 12V
Terminal capacity 1.5mm²
Humidity 5 to 95% non-condensing
Operational temp. ºC -10 to 35
Material (casing) Flame retardant ABS and PC/ABS
Compliance EMC-2014/30/EU
LVD-2014/35/EU
For further compliance information visit
www.cpelectronics.co.uk/compliance