CABAC HNKE8 User manual
A: 8 Distribution Pl, Seven Hills NSW 2147
1
BOOTLACE CRIMPER
25-185MM2
OPERATION MANUAL
HNKE8
A: 8 Distribution Pl, Seven Hills NSW 2147
2
1.
Assemble the handles and crimp body of the HNKE8.
Use the screws to secure the handles.
OPERATING INSTRUCTIONS – HNKE8
2.
Select the correct die size for the bootlace ferrule to
be crimped. Undo the screw on the lower piston with
an Allen key and insert the die with the indent ridge.
Then secure by tightening the screw.
3.
Secure the nest die in position as shown in the picture
and fasten in place with an Allen key.
4.
Strip the cable insulation to the required length of the
bootlace terminal. Insert the bare conductor into the terminal.
A: 8 Distribution Pl, Seven Hills NSW 2147
3
5.
Place the bootlace terminal and conductor in the nest die.
OPERATING INSTRUCTIONS – HNKE8
6.
Crimp the bootlace ferrule using the levers to compress
the dies.
7.
Trim excess copper conductor at the end of the
terminal if required. The crimp is complete.
Table of contents
