CableWholesale E-851 User manual

HDMI Cable Tester
Model No.E-851
Introduction
The HDMI (High Definition Multimedia Interface)Cable tester is designed to check
and troubleshoot the pin connections of HDMI cables. It is ideal for testing the
continuity of each pin of an HDMI cable prior to installation on equipments.
Features
zTest all pins signal of HDMI cables
zLED indicator on both main unit and remote unit
zAutomatic “on” and easy to operate
LED Definition (HDMI typeA cable pin-out)
LED LED
NAME HDMI
Pin Signal
1 TMDS Data2+
2 TMDS Data2 Shield
1 Data Red
3 TMDS Data2
4 TMDS Data1+
5 TMDS Data1 Shield
2 Data Blue
6 TMDS Data1–
7 TMDS Data0+
8 TMDS Data0 Shield
3 Data Green
9 TMDS Data0–
10 TMDS Clock+
11 TMDS Clock Shield
4 Clock
12 TMDS Clock–
5 CEC 13 CEC
14 Reserved (N.C. on device)
6 SCL 15 SCL
7 SDA 16 SDA
17 DDC/CEC Ground
8 +5 VOLTS 18 + 5V
9 Hot Plug 19 Hot Plug Detect
Specifications

Port Type HDMI (A)
Battery 9V Battery
Instructions for Operation
Step 1 : Install a 9V battery into the main unit which power will be supply
automatically.
Step 2 : Connect one end of the HDMI cable to the main unit (Transmitter), and the
other end to the remote unit (Receiver) of the HDMI Cable tester.
Test Result:
1. If all 9 LEDs are lit up, the cable is defined as pass.
2. If any LED do not light up, the inner pin of the corresponding signal is defined as
failed.