California Faucets SH-1320W Series User manual

SH-1320W_ii_190813 Pg 1
Showerhead
SH-1320W-ZZ
Shower & Waterfall Showerhead
Installation Instructions
1
2
•Place SHOWERHEAD (3) onto ROUGH
VALVE (2) and confirm that it is level
•Mark hole locations on finished wall
•Remove SHOWERHEAD (3) from ROUGH
VALVE (2)
•Using a ¼” drill bit, drill through TILE (4) and
BACKERBOARD (5)
IMPORTANT: Do not drill into BRACE (1) with ¼” drill bit
•Using a 7/64” drill bit, drill into BRACE (1)
•Apply SILICONE SEALANT (6) into drilled
holes and around ROUGH VALVE (2)
IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
Operating Specifications:
Recommended Supply Pressure: 20 to 70 psi *†
†If water pressure exceeds 70 psi, install a Pressure-Reducing Valve (PRV).
REMOVING MUDGUARD
v DRILLING HOLES IN TILE
CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED
BY A LICENSED PROFESSIONAL
No. 12
Screw Size
No. 3
Drive Size
7/64 Drill Bit Size
2-1/2”
0.216”
Mounting Screw
WARNING: Finished wall thickness MUST NOT
exceed 1-1/4”
WARNING: SHOWERHEAD (3) MUST be supported
while on ROUGH VALVE (2)
2a
2b
3
1
5
4
1/4” Drill Bit
1
5
4
7/64” Drill Bit
6
IMPORTANT: SHOWERHEAD (3) must be installed on finished wall
•Loosen SETSCREW (2a) and remove MUDGUARD
(2b)

SH-1320W_ii_190813 Pg 2
3
•Place SHOWERHEAD (3) onto ROUGH
VALVE (2) and align it with the drilled holes
•Secure SHOWERHEAD (3) with SCREW (7)
using a #3 drill bit (not supplied)
californiafaucets.com 5271 Argosy Ave. Huntington Beach, CA 92649 800-822-8855
INSTALLING SHOWERHEAD
WARNING: SHOWERHEAD (3) MUST be supported until
all screws are in place
7
3