Calspas Cal Designs Deluxe Spa Step WOOD118-KD User manual

2
Spa step assembly
LTR20091081, Rev. A
www.c alspas. com
These instructions describe the step-by-step procedure for assembling
the two-tier spa step. Before beginning, check the parts that came with
your step package to ensure everything you need is present.
Tools Required

3
Spa step assembly
LTR20091081, Rev. A
www.c als pas.com
Slide the plastic tabs on the under-
side of each step into the slots in
the side panels.

4
Spa step assembly
LTR20091081, Rev. A
www.c als pas.com
Tap the step and side panels
together until they are ush.

5
Spa step assembly
LTR20091081, Rev. A
www.c als pas.com
Place step upside down on a level
surface for support.

6
Spa step assembly
LTR20091081, Rev. A
www.c als pas.com
Insert four self-tapping screws
on the bottom side of the step.
Do this for all four sides.

7
Spa step assembly
LTR20091081, Rev. A
www.c als pas.com
Turn the step right side up.
Drill pilot holes for the screws using the 1/8” drill bit at
the distances shown.
Attach the cross-bar back support with four self-tapping
screws.

CONTACT INFORMATION
For customer service, please contact
your authorized dealer immediately. If
you need additional information and/or
assistance, please contact:
Customer Service Department
1462 East Ninth Street
Pomona, CA 91766
Toll Free: 1-800-CAL-SPAS
Fax: [phone]
www.calspas.com
Copyright 2009 LMS, Inc. All rights reserved. Duplication without written consent is strictly
prohibited.
Cal Designs ® is a registered trademark.
Due to continuous improvement programs, all models, operation, and/or specications are
subject to change without prior notice.
LTR20091081, Rev. A
4/24/09