II. Safety Instructions
IMPORTANT: Read all instructions prior to use and save for future reference.
Warning! Item is extremely hot and can burn if not handles properly� Handle only with protective oven mitts or gloves�
Warning! Do not heat the Camwarmer in microwave or broiler� Heat only in oven�
Warning! Do not re-heat warm or hot Camwarmers� Instructions are for room temperature parts�
Preheat oven to 350°F (177°C) and place entire Camwarmer unit inside oven for 45 minutes� Do not separate the outer trays from the inner pellet� Heat units in a
single layer� If 2-3 Camwarmers need to be stacked and heated at the same time, extend heating time to 2 hours�
Note: Do not heat more than 5 stacked Camwarmers in the oven at once� Uneven and inadequate heating will occur� Do not heat for more than 5 hours at a time�
To preheat the compartment: Use oven mitts to slide the heated Camwarmer onto the bottom rails of your Cambro insulated transporter or place the Camwarmer
onto a sheet pan that will slide onto the rails�
Caution! Do not place the Camwarmer or any other hot items directly onto the bottom of the compartment� This may cause permanent damage to plastic� If heating
Camwarmer longer than 30 minutes, make sure to cool it down to 250° (121°C) before placing into the transporter�
To extend holding times: use two Camwarmers per compartment� Preheating is no longer necessary�
Serving tip: Remove bottom food pan rst and move both Camwarmers up as food pans are being taken out�
Allow Camwarmer to cool for at least 8 hours before cleaning�
Unit must be taken apart for complete cleaning�
All components are dishwater safe�
1� Remove the bottom tray from the top tray by using the small bumps on the bottom
to turn the tray counterclockwise and then lift out�
2� After washing and drying, align molded-in arrows on bottom tray and then turn
clockwise to secure back together�
Please visit www�cambro�com for a complete list of replacement parts�
TO ORDER REPLACEMENT PARTS:
• Call Cambro Customer Service at 800 833 3003 or
• Fax your order to 714 842 3430 or
• Call your local Cambro Representative or Distributor
All Camwarmers are factory assembled for your convenience� No assembly required� Remove packing tape, tags or documents
from inside compartment before using�
III. Heating and Handling Instructions
IV. Assembly
V. Cleaning
© Cambro Manufacturing Company, 5801 Skylab Road, Huntington Beach, CA 92647-2056
714 848 1555 / Toll Free 800 854 7631 / FAX 714 842 3430 / Customer Service 800-833-3003
UMCMWRM0714 REV A Printed in USA
D051533
VI. Replacement Parts
VII. Cambro Warranty and Product Liability
CAMBRO WARRANTY AND PRODUCT LIABILITY
Cambro warrants to the original buyer that if a product proves defective:
1� Within 1 year from the date of manufacture, Cambro will replace the product free of charge; or,
2� After 1 year and up to 2 years from the date of manufacture, Cambro will grant a credit of 2/3 off replacement product; or,
3� After 2 years and up to 3 years from the date of manufacture, Cambro will grant a credit of 1/3 of the original price towards a replacement product�
ABUSE OR MISUSE WILL VOID THIS WARRANTY
In the event of a defective product, your Cambro Sales Representative will collect appropriate information, such as date of manufacture and invoice information for
warranty process� With proof of purchase to the original owner, Cambro Manufacturing will replace the product to the original owner�
NOTE: Your Cambro Sales Representative will determine if the product should be returned for inspection before issuing credit�
Bottom Tray
Top Tray
Pellet
Turn
clockwise
to secure in place
Consists of three parts - A heat retentive pellet enclosed within a
top and bottom tray made of heat resistant material.
