Cambro CAMBAR BAR730110 Maintenance manual

www.cambro.com
CARE AND MAINTENANCE FOR ALL CAMBAR MODELS
Congratulations on the purchase of your new Cambro Cambar! Although the bar is designed to be weather - proof,
please avoid exposing the bar to direct sunlight for prolonged periods of time and avoid placing it in situations
where it can absorb the high intensity sunlight reected from glass or other mirrored surfaces. Avoid situations
where temperatures may exceed 200˚F as this may cause damage to your bar.
CLEANING INSTRUCTIONS
For all body parts such as the main body section, front body panel section, speed rail,
waste water bin and fresh water tank:
It is recommended to use Gel-Gloss®cleaner
and polish, following the instructions on the
back of the container.
• Clean with a soft cloth, plastic or bristle brush and warm soapy water or a mild commercial detergent. Sanitizing solutions are also recommended.
• Rinse thoroughly with clean water. If staining occurs use a standard de-stainer such as Dip It®Cleaner.
• All parts can also be steam cleaned.
• A diluted solution of 2-3 tablespoons of baking soda per gallon of hot tap water or 1 part lemon juice or vinegar to 4 parts hot water is also an
effective way to remove lingering odors.
• Rinse thoroughly with hot water and let air dry or wipe down with a soft cloth.
Use an odor removing soak or sanitizer to remove scents and stains that can occur from holding products with strong odors.
WARNING! Never use a metal brush, abrasive cleaners or pads.
To remove any lingering scents and stains:
To maintain a shiny finish to the granite style counter tops
of the designer series:

D021606 Cambar Care & Maintenance INSCAMBAR MN
Fig. 1
Nylon bushing or
ball bearing
“O” Ring or Seal
Swivel Raceway Fig.2
Telephone [phone] Toll Free 800 854 7631 Customer Service 800 833 3003
© Cambro Manufacturing Company 5801 Skylab Road, Huntington Beach, California 92647-2056
Printed in USA 3/16 INSCAMBAR
CASTER MAINTENANCE
CLEANING INSTRUCTIONS (continued)
The following products have been
found to be compatible:
• Isopropyl alcohol
• Joy®Dishwashing Liquid
• Mr. Clean®
• Palmolive®
• Windex®Ammonia-D
To clean the decorative front and side panels of the designer series:
To be performed after unit has been washed or steam cleaned:
1. Grease swivel raceway of caster using a lubricant such as Lubriplate No. 930-AA, Keystone #84EPXLT multi-purpose grease or the equivalent.
Moving “O” Ring or seal with finger, apply grease using a grease gun with a needle nose adapter or a tube-type applicator such as “Sta-lube”
Moly-graph Assembly Lube (Fig. 1). These can be obtained at most auto parts stores.
2. Use a light oil such as WD-40 on the nylon bushing at the hub (Fig. 2).
3. Check caster for any damage and test caster spin and swivel rotation before returning to service.