Aluminum die-casting housing.
The camera is designed for compact size and waterproof housing.
The h
Auto-lris makes the picture fine in any bright condition.
ighest quality of CCD provides you with the best picture.
1. Features
2. Installation
(1) Determine a position and a direction of installation so that the rear view can be
effectively seen on the monitor screen.
(2) Fix the camera bracket to the vehicle using the provided adhesive tape and
tapping screws with spring washers.
Run the cable from the monitor to the camera.
(3)
CAMERA CONNECTOR
①②
③④
⑤⑥
⑦
< CM-43/43P >
=
=
=
=
=
Pin No Description
1
2
3
4
5
6
7
POWER IN(DC +12V)
NC
NC
VIDEO OUT
NC
NOR/MIR
GND
Tapping screw
(TH) 4x18
Adhesive tape
Safeguard tape
Camera Bracket
3. Connection
!
Before making the connection, disconnect the ground terminal of the car
battery to avoid short circuiting.
The plug should be fully inserted into connector or jack. A loose
connection may malfunction of the unit.cause
Machine screw
(PH) M3x6
Machine screw
(PH) M3x6
2 3
Monitor (Option)
Camera
Water proof
Connector
Extension Cable
Wedge Washer
(M3)
Wedge Washer
(M3)
