Campania International Williamsburg Pineapple User manual

F
T
-
132
WilliamsburgPineapple 2
-
Tier
Fountain
Two people are recommended for the installation ofthisfountain!
R
evised
March1
1, 2017
-WINTERCARE-
Fountainbowls/topsandotherfountaincomponents,whichcollect water, shouldnotbeleftoutsideinthewinter since anycomponent,
whichfillswithwater andfreezesmaycrack.Likewisecomponentssuchaspedestals,whichremaininabasin,filledwithwater,
whichthenfreezes,mayalsocrackor crumble. Ideally, therefore, afountainshouldalwaysbestoredindoorsor inadryprotected
place suchasacoveredporchawayfromtheelements. However, ifafountainmustbeleftoutside:
(1) Removepump, rubber stoppers, drainpipes, finials,andother smallcomponentsfor storageindoors. Note that stoppersor
drainpipesareremovedtoallowdrainageintheeventwater accumulatesinanybasin.
(2) Raisefountainbasefromgroundwithwood stripssothat basewill notfreeze tothegroundsurface.
(3) Cover or wrapthefountainwithburlapor other absorbentmaterial (oldblanket or towel) andthencover securelywith
plastic,making surethat water will notaccumulate inthebasinor other fountaincomponentandfreeze;
(4) Checkfountainperiodicallytoinsurethat plastic issecureandwater isnotaccumulating inanyfountaincomponent.
-GENERALFOUNTAINTIPS-
Install fountainsonalevel surface. Youwill needaproperlygrounded110-volt (AConly) GFCI protectedreceptaclenear the
fountainfor your pump. All pumpsaresubmersible andmustbecompletelyunderwater tofunctionproperly. Testall pumpsand
adjusttofull outputprior toassembly. Itisnotrecommendedthat fountainsbeplaceddirectlyongrass or dirt. Positionthechannel
opening at thebaseofeachfountaintoward theelectrical outlet tobeusedsince thepump
cord willbethreadedthroughthisopening.
CheckoutYouTubefor a“Howto”video.
For moreCampania product informationvisit www.campaniainternational.com
All of ourcaststone is proudly
Pump KitPartsList
PK300 pump (1)
#7 stopper(1)
Approx.24”length of1/2”blacknon-kinktubing (1)
Wedges(4)
Hose clamps(3)*
*Hoseclamps maybe used asflow restrictors
FOUNTAININFORMATION:
Thisfountain holdsapproximately5gallonsof water.
Thisfountain usesamediumfountain cover.
(FTNCOV-MED)
Compatible withRefill #7 Device and LEDKit
(A different style stopper mayberequestedfor therefillkit.)
TOOLSREQUIRED:
Bubble Level
PUMPINFORMATION:
OEMPF320 - 320GPH Pump
16 FTcord length

F
T
-
132
WilliamsburgPineapple 2
-
Tier
Fountain
Two people are recommended for the installation ofthisfountain!
R
evised
March1
1, 2017
Assembleyourfountainonalevelsurface capableofholdingaminimumof331 poundswithanapproximate1squarefootfootprint.
FT-132G (135lbs)
12.75”W x25.75”H
FT-132F(111 lbs)
30”W x8.5”H
FT-132D (7lbs)
7.5”W x5.5”H
FT-132C(11 lbs)
7”W x9”H
FT-132B(20 lbs)
16.5”W x4.5”H
FT-132A(3lbs)
3.75”W x7”H
FT-132E(1lb)
4.75”Lx1.5”W x4”H
1. Placethe base (FT-132G)into position where the fountain willbe installed, ensuringthat
it islevel.
a. Note:Check thatall components are leveledasthe fountain isassembled.
2. Positionthe large bowl(FT-132F)overthe base (FT-132G).
3. Assemble the fountain plumbing
a. Attach the 1/2” non-kinktubingto the pump outlet.
b. Placea hose clamp overtheotherendofthe 1/2"non-kinktubing
c. Placethe stopperaround the pump cord approximately8” fromthe pump.
4. Feed the pump cordallthe waythrough the hole inthelarge bowl(FT-132F), through the
base(FT-132G).
5. FIRMLY press the stopperintothe hole evenly.
a. Note:Usingthehandle ofascrewdriverorhammerworksbestto pressthe
stopperin place.
6. Placethe pump cover(FT-132D)overthe pump.
7. Placethe small pedestal(FT-132C)overthe pump cover(FT-132D).
8. Feed the tubingthrough the holeinthe centerofthe small pedestal(FT132C).
9. Positionthe small bowl(FT-132B)overthe small pedestal(FT-132C).
10. Connectthe 1/2"non-kinktubingtothe pipe protruding fromthe bottomofthe small
bowl(FT-132B)with the hose clamp.
11. Fit the finial(FT-132A)into the small bowl (FT-132B)byfeedingthe protrudingcopper
pipe fromthe bowlintothe copperpipe holein the finial.
12. Placethe pump coverdoor(FT-132E)intothepump cover(FT-132D).
13. Fillthe fountain with water.