CAN-BUS EMULATOR id-v6 User manual

USER MANUAL
INSTALLATION OF ZETOR ADBLUE EMULATOR
www.canbusemulator.com/en
[phone]
erenakarsubasi

INSTALLATION OF ZETOR ADBLUE REMOVAL EMULATOR
Emulator all cable must be connect on diagnostic
tool socket
Red taken from fuse... +15 terminal (You can use
fuse F10 for red cable)
So we do not remove the fuse because we cut the
cable.
www.canbusemulator.com

You need to cut the cable of the 25th
and 17th pins in the socket shown in
the image.(socket x40)
You need to pull the 5A fuse numbered F33. Its location is indicated in
the images below.
INSTALLATION OF ZETOR ADBLUE REMOVAL EMULATOR
www.canbusemulator.com

INSTALLATION OF ZETOR ADBLUE REMOVAL EMULATOR
You can cut the cable of pin 11 in the
socket and connect the red cable of the
emulator to this pin (power +15).
Pin 3 to Green wire of Emulator (CAN L)
Pin 4 to Yellow wire of Emulator (CAN H)
Pin 24 to Black Wire (GND) of Emulator
must be connected.
You need to cut the cable of the 25th
and 17th pins in the x40 socket.
If you connect the emulator to this
socket, you do not need to pull the
fuse.
www.canbusemulator.com