www.canbusemulator.com/en
Installation
Emulator
For
DAF
Euro
6
DAF EURO 6 ADBLUE CANCEL EMULATOR INSTALLATION
You must attach the emulator to the rear of the silencer under the EAS ECU.
You must first disconnect the NOx sensor cables and connect the emulator cables to the NOx
cables.
You must obtain fuse F22 (e497, 15A)
CAN cables are located at the top of the NOx socket.
Car
side
Emulator
side
CAN
H
-------------------->
YELLOW
cable
CAN
L
-------------------->
GREEN
cable
POWER
(+)
-------------->
RED
cable
GND
(-)
------------------->
BLACK
cable
IMPORTANT NOTE: Only the CAN cables are to be connected from the NOx socket as the
truck's fuse has been taken. For power connections you need to use ground (GND) and
contact (+).
You must clear the error codes from the engine ECU. If you do not have DAVIE software, you
can use DAF Euro 6 DTC Eraser.
The connection type DAF460 / 480 is the same but the NOx socket locations are different. The
following are shown.
DAF460
