CANARMNA LUL-14 User manual
LED PUCK LIGHT
TOOLS AND MATERIALS REQUIRED:
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY
TO PERSONS READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
CAUTIONS:
!Wiring supplies
as required by
local electrical
code
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Step 1
Step 2
Step 3
Step 1
Step 2
Step 3
Recessed Installation
1. Installation, Operating and Safety Instructions - Instructions for installation and use of this
product are provided by the manufacturer.
by 12 inches".
3. For under cabinet or shelf mount only.
Using included hardware and a screw driver,
secure outer shell to cabinet surface.
Using hands, separate outer shell from LED Iamp.
Cut out from the bottom of the cabinet a hole
using a 2.5”hole saw.
Feed connecting cord through a pre-drilled hole in the cabinet surface
or through the cut-out of the outer shell. Secure LED lamp into outer shell.
Feed connecting cord through the hole in
cabinet and secure LED lamp.
Surface Mount Installation
Using hands, separate outer shell from LED lamp.
For hardwire box wire diagram please see page 2
1.Tur power to house electrical supply
wire.
2.Wire Hardwire box to house electrical supply
wire with strain relief supplied with hardwire
box.
3. Plug driver into hardwire box.
4. Plug power block into supply wire from driver.
5. Plug LED puck light into power block.
6. Make sure all wires are secured correctly.
06/20
LUL-14
1-800-265-1833 (English) / 1-800-567-2513 (French)
Monday through Friday 8:00 AM to 5:00 PM E.S.T.
Questions or Concerns Contact At The Following Phone Numbers Before
Returning Product To The Store:
Page 1 of 2
Hardwire install
Plug in install
maximum 6 pucks linkable
(additional pucks sold separately)
Hardwire Box and HUB Installation Instruction (JUNCTION BOX SOLD SEPERATELY)
Jumper Cable to Connect to Fixture
Install the strain relief on the
hardwire box
Unscrew the hardwire box
Screw the hardwire box
Install the HUB on the cabinet
Install the hardwire
box on the cabinet
Wire Guide
Connect the black
wire (Hardwire Box)
to black wire
(Branch circuit)
Connect the white wire (Hardwire Box)
to white wire (Branch circuit)
Strain Relief
1
4
3
5 6
2
Remove the
knock-out
Tel: (613) 342-5424, Fax: (800) 263-4598 Page 2 of 2
