Canon PIXMA MX882 Series User manual

Installing Your Multifunction
to Your Network for the First Time
PIXMA MX882
Mac OS
1

Navigation Tips for Macintosh Users
2
To navigate this guide, please use the arrows on the MAC
keyboard or use the PAGE UP and Page DOWN keys.
Page UP
Page DOWN
LEFT
UP
DOWN
RIGHT

Installing Your Multifunction
to Your Network for the First Time
PIXMA MX882
Mac OS
Preparing to Connect My Multifunction to My Network 4
Network Requirements 4
Important Information You Need Before Adding Your Multifunction 5
Adding Your Multifunction to Your Network 6
Installing the Drivers & Software 11
Registering the Printer & Scanner 16
3

Network Requirements
Before connecting the machine to the network, make sure that configuration of the computer and access point or router is
complete, and that the computer is connected to the network.
Notes on Network Connection
•The configuration, router functions, setup procedures and security settings of the network device vary depending on your
system environment. For details, refer to your device's instruction manual or contact its manufacturer.
•The machine cannot be used over a wireless and wired connection at the same time.
Wireless Connection
Connect to your network environment over a wireless connection.
Preparing to Connect My Multifunction
To My Network
4

Preparing to Connect My Multifunction
To My Network
Be sure to prepare an access point.
Important Information You Need Before Adding Your Multifunction
The following information is required to connect to your access point or router.
•Access Point Name/Network Name:
Also referred to as SSID. A name to identify the specific access point.
•Network Key:
Also referred to as encryption key, WEP key or WPA/WPA2 passphrase, Pre-Shared key.
A password required to set to prevent unauthorized access to communication.
Check your access point or router for the following information, and then write it down.
NOTE: For details on how to check the following information, refer to the manual of your access point or router, or contact its manufacturer.
An "Ad-hoc connection," which establishes a direct
connection to the computer over a wireless connection
without using an access point, is not supported.
5

Adding Your Multifunction to Your Network
Adding Your Multifunction to Your Network
6
Step One
Press the Setup button (A)
Step Two
Use the or button (B) to select Wireless LAN setup, then
press the OK button

Adding Your Multifunction to Your Network
7
Step Four
Select Easy setup, and then press the OK button.
Step Three
Select Yes, then press the OK button.
When wireless connection is enabled, the Wi-Fi lamp (D)
lights blue.

Step Five
Select the access point name, then press the OK button.
NOTE: If you are living in an apartment, nearby access
points in use may be detected.
Step Six
Make sure that one of the screens, below, is displayed, then press
the OK button..
If the following screen is not displayed, go to step 9
Adding Your Multifunction to Your Network
8

Step Eight
Make sure that the network key is correct, then press the left
FUNCTION button. (below End setup)
.
Adding Your Multifunction to Your Network
9
Step Seven
Enter the network key you wrote down, then press the
left FUNCTION button (E).
Press the center FUNCTION button (F) to switch
character entry modes.
Network key entry is case-sensitive. Be sure to enter upper
and lower case
letters correctly.

Adding Your Multifunction to Your Network
10
Step Nine
When the screen below appears, press the OK button.
If Failed to connect to the access point. appears, press the
OK button, make sure that the network key is correct, then
enter it again. If a connection still cannot be established, refer
to the printed manual: Network Setup Troubleshooting.